Check out the CONTINUE command.
IMDONE=''
LOOP UNTIL IMDONE
Block code
Block code
IF condition THEN
IMDONE=1
CONTINUE
END
REPEAT
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of George Gallen
Sent: Monday, February 07, 2011 12:26 PM
To: U2 Users List
Subject: [U2] Does UV have a "BLOCK" command
I want to setup a block of commands, and be able to exit out of the
block if needed.
Right now I use a LOOP/REPEAT with an EXIT statement before the REPEAT.
I'd rather not use labels (or subroutines).
The Loop/Repeat works, it just looks weird since it isn't really a
loop...
I tried using an IF block, but I couldn't use the EXIT within that block
IF (1=1) THEN..........END
LOOP
block code
block code
if condition then EXIT
block code
EXIT
REPEAT
Would be nice if....
BEGIN BLOCK
block code
block code
if condition then EXIT
block code
END BLOCK
George Gallen
Senior Programmer/Analyst
Accounting/Data Division, EDI Administrator
[email protected]
ph:856.848.9005 Ext 220
The Wyanoke Group
http://www.wyanokegroup.com
_______________________________________________
U2-Users mailing list
[email protected]
http://listserver.u2ug.org/mailman/listinfo/u2-users
_______________________________________________
U2-Users mailing list
[email protected]
http://listserver.u2ug.org/mailman/listinfo/u2-users
