My DFS code was written 10/30/2012 if that helps identify the version. If you're in compliance test mode I expect all the DFS enable stuff is probably ignored.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Sun, Dec 7, 2014 at 2:26 PM, Matt Hoppes <[email protected]> wrote: > I don't recall which firmware version the DFS code appeared in. It's > definitely in 5.5.8. > > Downgrade to 5.5.8. Enter the code. Re-upgrade to 5.5.10. > > I think you blew past the DFS enable firmware :) > > On Dec 7, 2014, at 1:45 PM, Mike Hammett <[email protected]> > wrote: > > I have some old Rockets (maybe 5.2.1 vintage?). I upgraded them as needed > throughout the years. The past day or two, performance in on part of the > network has been erratic to say the best of it. > > I noticed that they were in Compliance Test mode, but didn't have the > input boxes for the DFS stuff, so I must have entered it at one point, but > never actually moved over. They were on 5.5.2. > > Don't fuck with what works. Well, now it's not working right. > > I upgrade to 5.5.4, then 5.5.10. I set the country code to US.... no DFS > channels show up on the AP. > > Do I need to reboot it after setting it to US so that I can get the DFS > channels? > > A reset to defaults and starting over is kinda out of the question at the > moment. > > Any other ideas? > > If I have to climb to replace radios, ePMPs are going up instead. > > > > > > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > > _______________________________________________ > Ubnt_users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/ubnt_users > > > _______________________________________________ > Ubnt_users mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/ubnt_users > >
_______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
