Hi all, I've got several links setup with the new Litebeam 120 sector APs and the Litebeam AC CPEs. One of the links I have shows extremely poor transmit numbers when I run a speed test, but it always shows slow transmit problems depending on which end of the link I'm on. Here's the link
Tower w/Litebeam AP 120 --> Litebeam CPE on shed <-- Shed --> Litebeam 120 mounted back-to-back with CPE --> Another Litebeam CPE on a client's house. The Tower->Shed link is about 2.5 miles LOS and sits at about -56 on both Chain 0/1, the Shed->House link is less than 1/4 mile and it's also LOS with about a -42 signal on both chains. All devices are running 8.0-beta19, which has been otherwise pretty solid as far as I can tell. If I login to the AP at the tower, I get approximately 6Mbps RX, 0.75Mbps to the house CPE. If I login to the house CPE, I get the same thing (6Mbps RX, 0.75Mbps TX) to the AP. If I login to the edgerouter in the shed which bridges the two wireless connections, I get much better results, roughly 25-35Mbps each way. Has anyone else seen this? I worried the short link was too hot at -42, so I've temporarily turned on the auto power control to see if it helps. So far it has reduced the power, but hasn't seemed to help the end-to-end speeds.
_______________________________________________ Ubnt_users mailing list [email protected] http://lists.wispa.org/mailman/listinfo/ubnt_users
