I did it a couple of times. The first time scared me when the web UI showed
only 3 ethernet interfaces. But you can create the other interfaces in the
CLI. Then it seemed to be 100%. The second time was with a newer edgeOS. The
interfaces were just greyed out that time. I went to the CLI again and all was
well.
On January 29, 2017 6:42:18 PM CST, Shawn Burgei <[email protected]> wrote:
>It is not dead. We are upgrading to the Pro and was hoping we can just
>dump the config. But will give that a shot! Thx
>
>Sent from my iPhone
>
>> On Jan 29, 2017, at 7:37 PM, Chris J. Ruschmann <[email protected]>
>wrote:
>>
>> Is the Lite dead?
>>
>> If not, run 'show configuration commands', copy those commands to the
>new router and make sure the interfaces match up. This is the Cisco
>style of configuring that I like best.
>>
>> -----Original Message-----
>> From: [email protected]
>[mailto:[email protected]] On Behalf Of Shawn Burgei
>> Sent: Sunday, January 29, 2017 3:33 PM
>> To: [email protected]
>> Subject: [Ubnt_users] EdgeRouter
>>
>> Does anyone know if you can take the EdgeRouter Lite config and
>upload it to the EdgeRouter Pro?
>>
>> Thanks
>> Shawn
>>
>> Sent from my iPhone
>> _______________________________________________
>> Ubnt_users mailing list
>> [email protected]
>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>> _______________________________________________
>> Ubnt_users mailing list
>> [email protected]
>> http://lists.wispa.org/mailman/listinfo/ubnt_users
>
>_______________________________________________
>Ubnt_users mailing list
>[email protected]
>http://lists.wispa.org/mailman/listinfo/ubnt_users
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
_______________________________________________
Ubnt_users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/ubnt_users
