When I try it with workaround 8 it works.  With workaround 1 the output
is a little bit weared. I did however not reboot the system... just
unmounted the ipod and unplugged it.

dmesg gives the following output with workaround 8:
[ 2885.950819] ieee1394: Node added: ID:BUS[0-00:1023]  GUID[000a27000275787b]
[ 2885.952264] ieee1394: Node changed: 0-00:1023 -> 0-01:1023
[ 2885.956693] scsi4 : SBP-2 IEEE-1394
[ 2885.957798] ieee1394: sbp2: Workarounds for node 0-00:1023: 0x8 
(firmware_revision 0x0a2700, vendor_id 0x000a27, model_id 0x000000)
[ 2887.420819] ieee1394: sbp2: Logged into SBP-2 device
[ 2887.421893] ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload 
[2048]
[ 2887.424945] scsi 4:0:0:0: Direct-Access-RBC Apple    iPod             1.53 
PQ: 0 ANSI: 2
[ 2889.357625] sd 4:0:0:0: [sdc] Spinning up disk....ready
[ 2890.363890] sd 4:0:0:0: [sdc] 29297519 512-byte hardware sectors (15000 MB)
[ 2890.366909] sd 4:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 2890.377987] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, 
doesn't support DPOor FUA
[ 2890.388656] sd 4:0:0:0: [sdc] 29297519 512-byte hardware sectors (15000 MB)
[ 2890.392016] sd 4:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 2890.394776] sd 4:0:0:0: [sdc] Write cache: disabled, read cache: enabled, 
doesn't support DPOor FUA
[ 2890.396372]  sdc: sdc1 sdc2
[ 2890.415166] sd 4:0:0:0: [sdc] Attached SCSI removable disk
[ 2890.416311] sd 4:0:0:0: Attached scsi generic sg3 type 14


workaround 1 gives the following output in dmesg:
[ 3062.700133] ieee1394: Node changed: 0-01:1023 -> 0-00:1023                   
                 
[ 3062.701250] ieee1394: Node suspended: ID:BUS[0-00:1023]  
GUID[000a27000275787b]               
[ 3062.710159] sd 4:0:0:0: [sdc] READ CAPACITY failed
[ 3062.710171] sd 4:0:0:0: [sdc] Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK,SUGGEST_OK
[ 3062.710177] sd 4:0:0:0: [sdc] Sense not available.
[ 3062.710903] sd 4:0:0:0: [sdc] Write Protect is off
[ 3062.710910] sd 4:0:0:0: [sdc] Mode Sense: 00 00 00 00
[ 3062.711299] sd 4:0:0:0: [sdc] Asking for cache data failed
[ 3062.711307] sd 4:0:0:0: [sdc] Assuming drive cache: write through
[ 3062.711866] sd 4:0:0:0: [sdc] READ CAPACITY failed
[ 3062.711872] sd 4:0:0:0: [sdc] Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK,SUGGEST_OK
[ 3062.711876] sd 4:0:0:0: [sdc] Sense not available.
[ 3062.712044] sd 4:0:0:0: [sdc] Write Protect is off
[ 3062.712047] sd 4:0:0:0: [sdc] Mode Sense: 00 00 00 00
[ 3062.712799] sd 4:0:0:0: [sdc] Asking for cache data failed
[ 3062.712807] sd 4:0:0:0: [sdc] Assuming drive cache: write through
[ 3062.713699] sd 4:0:0:0: [sdc] Stopping disk
[ 3062.714477] sd 4:0:0:0: [sdc] START_STOP FAILED
[ 3062.714482] sd 4:0:0:0: [sdc] Result: hostbyte=DID_NO_CONNECT 
driverbyte=DRIVER_OK,SUGGEST_OK
[ 3080.896573] ieee1394: Node resumed: ID:BUS[0-00:1023]  GUID[000a27000275787b]
[ 3080.897971] ieee1394: Node changed: 0-00:1023 -> 0-01:1023
[ 3080.900127] scsi5 : SBP-2 IEEE-1394
[ 3080.906084] ieee1394: sbp2: Workarounds for node 0-00:1023: 0x1 
(firmware_revision 0x0a2700, vendor_id 0x000a27, model_id 0x000000)
[ 3082.097984] ieee1394: sbp2: Logged into SBP-2 device
[ 3082.099076] ieee1394: sbp2: Node 0-00:1023: Max speed [S400] - Max payload 
[2048]
[ 3082.103488] scsi 5:0:0:0: Direct-Access-RBC Apple    iPod             1.53 
PQ: 0 ANSI: 2
[ 3084.051135] sd 5:0:0:0: [sdc] Spinning up disk....ready
[ 3085.065227] sd 5:0:0:0: [sdc] 29297520 512-byte hardware sectors (15000 MB)
[ 3085.068427] sd 5:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 3085.071099] sd 5:0:0:0: [sdc] Write cache: disabled, read cache: enabled, 
doesn't support DPOor FUA
[ 3085.081000] sd 5:0:0:0: [sdc] 29297520 512-byte hardware sectors (15000 MB)
[ 3085.084206] sd 5:0:0:0: [sdc] Test WP failed, assume Write Enabled
[ 3085.086917] sd 5:0:0:0: [sdc] Write cache: disabled, read cache: enabled, 
doesn't support DPOor FUA
[ 3085.088583]  sdc: sdc1 sdc2
[ 3085.098304] sd 5:0:0:0: [sdc] Attached SCSI removable disk
[ 3085.099442] sd 5:0:0:0: Attached scsi generic sg3 type 14

-- 
Firewire IPOD does not work since upgrade to 8.10
https://bugs.launchpad.net/bugs/294391
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.

-- 
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to