Public bug reported:
The wireless stopped working after update and so did the wired.
The wireless gives this in dmesg:
[ 55.623817] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-2.ucode
[ 55.839738] iwl3945 0000:03:00.0: loaded firmware version 15.32.2.9
[ 55.909095] Registered led device: iwl-phy0::radio
[ 55.909117] Registered led device: iwl-phy0::assoc
[ 55.909176] Registered led device: iwl-phy0::RX
[ 55.909194] Registered led device: iwl-phy0::TX
[ 55.966425] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 57.428863] sky2 eth0: Link is up at 100 Mbps, full duplex, flow control
both
[ 57.429073] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 57.928117] lo: Disabled Privacy Extensions
[ 62.035121] [drm] TV-14: set mode NTSC 480i 0
[ 62.175386] [drm] TV-14: set mode NTSC 480i 0
[ 62.463084] [drm] TV-14: set mode NTSC 480i 0
[ 62.603075] [drm] TV-14: set mode NTSC 480i 0
[ 62.895096] [drm] TV-14: set mode NTSC 480i 0
[ 63.035305] [drm] TV-14: set mode NTSC 480i 0
[ 68.140019] eth0: no IPv6 routers present
[ 103.311365] [drm] TV-14: set mode NTSC 480i 0
[ 103.451525] [drm] TV-14: set mode NTSC 480i 0
[ 103.779062] [drm] TV-14: set mode NTSC 480i 0
[ 103.919131] [drm] TV-14: set mode NTSC 480i 0
[ 104.196974] [drm] TV-14: set mode NTSC 480i 0
[ 104.338064] [drm] TV-14: set mode NTSC 480i 0
[ 168.208594] wlan0: authenticate with AP 00:1d:0f:ba:03:ca
[ 168.210322] wlan0: authenticated
[ 168.210327] wlan0: associate with AP 00:1d:0f:ba:03:ca
[ 168.214571] wlan0: RX AssocResp from 00:1d:0f:ba:03:ca (capab=0x431 status=0
aid=1)
[ 168.214578] wlan0: associated
[ 168.216500] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 168.315661] cfg80211: Calling CRDA for country: ZA
[ 168.320077] cfg80211: Received country IE:
[ 168.320082] cfg80211: Regulatory domain: ZA
[ 168.320086] (start_freq - end_freq @ bandwidth), (max_antenna_gain,
max_eirp)
[ 168.320092] (2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[ 168.320096] cfg80211: CRDA thinks this should applied:
[ 168.320099] cfg80211: Regulatory domain: ZA
[ 168.320102] (start_freq - end_freq @ bandwidth), (max_antenna_gain,
max_eirp)
[ 168.320107] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 168.320113] (5170000 KHz - 5250000 KHz @ 20000 KHz), (300 mBi, 1700 mBm)
[ 168.320118] (5250000 KHz - 5330000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 168.320123] (5490000 KHz - 5710000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 168.320128] (5735000 KHz - 5835000 KHz @ 20000 KHz), (300 mBi, 3000 mBm)
[ 168.320132] cfg80211: We intersect both of these and get:
[ 168.320135] cfg80211: Regulatory domain: 98
[ 168.320138] (start_freq - end_freq @ bandwidth), (max_antenna_gain,
max_eirp)
[ 168.320143] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 168.320152] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320157] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320162] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320166] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320171] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320176] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320180] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320185] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320189] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320194] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320199] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320203] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320208] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule
found in band on Country IE
[ 168.320213] cfg80211: Current regulatory domain updated by AP to: ZA
[ 168.320217] (start_freq - end_freq @ bandwidth), (max_antenna_gain,
max_eirp)
[ 168.320222] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[ 168.840223] padlock: VIA PadLock not detected.
[ 178.324062] wlan0: no IPv6 routers present
[ 213.473149] CE: hpet increasing min_delta_ns to 15000 nsec
[ 214.662268] wlan0: disassociating by local choice (reason=3)
For the wired network I cannot get the settings through dhcp.
I am able to connect if I set the ip, route, etc manually (ifconfig,
route etc).
Description: Ubuntu karmic (development branch)
Release: 9.10
2.6.31-9-generic #29-Ubuntu SMP Sun Aug 30 17:39:23 UTC 2009 i686 GNU/Linux
** Affects: ubuntu
Importance: Undecided
Status: New
--
Wireless and wired network stopped working after update
https://bugs.launchpad.net/bugs/428844
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
