** Description changed: Binary package hint: wodim When I want to erase a CD-RW with wodim 1.1.9 (under Ubuntu 9.10), I get an error message and the disk is not erased. The same command works fine in Ubuntu 9.04 before I upgraded Ubuntu to 9.10. As Brasero and K3b also use wodim they also cannot erase CD-RWs anymore after upgrading to 9.10... Below is the output of wodim under Ubuntu 9.10 and 9.04... Thanks, Andreas + + Edit: this seems to be a kernel issue: after downgrading the kernel to + 2.6.28-10 (originally I had 2.6.31-17 under Ubuntu 9.10) I was able to + erase CD-RWs. However, this can't be the solution to the problem as I + don't want to use an old kernel. Also the problem apparently still + exists with kernel 2.6.32-7 under Ubuntu 9.10: andr...@alix:~$ /usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=4 -tao driveropts=burnfree blank=fast TOC Type: 1 = CD-ROM /usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/sr0' devname: '/dev/sr0' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.9 Driveropts: 'burnfree' SCSI buffer size: 64512 Device type : Removable CD-ROM Version : 0 Response Format: 2 Capabilities : Vendor_info : 'Optiarc ' Identification : 'DVD RW AD-7200A ' Revision : '1.06' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x000A (CD-RW) Profile: 0x002B (DVD+R/DL) Profile: 0x001B (DVD+R) Profile: 0x001A (DVD+RW) Profile: 0x0016 (DVD-R/DL layer jump recording) Profile: 0x0015 (DVD-R/DL sequential recording) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x0012 (DVD-RAM) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0010 (DVD-ROM) Profile: 0x000A (CD-RW) (current) Profile: 0x0009 (CD-R) Profile: 0x0008 (CD-ROM) (current) Profile: 0x0002 (Removable disk) Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R Drive buf size : 866304 = 846 KB Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. Current Secsize: 2048 ATIP info from disk: Indicated writing power: 5 Reference speed: 2 Is not unrestricted Is erasable ATIP start of lead in: -11745 (97:25/30) ATIP start of lead out: 359849 (79:59/74) 1T speed low: 0 (reserved val 0) 1T speed high: 4 2T speed low: 0 (reserved val 5) 2T speed high: 0 (reserved val 12) power mult factor: 4 6 recommended erase/write power: 3 A1 values: 02 4C B0 A2 values: 5C D8 36 Disk type: Phase change Manuf. index: 40 Manufacturer: INFODISC Technology Co., Ltd. Speed set to 706 KB/s Starting to write CD/DVD at speed 4.0 in real BLANK mode for single session. Last chance to quit, starting real write in 0 seconds. Operation starts. Performing OPC... Blanking PMA, TOC, pregap Errno: 5 (Input/output error), blank unit scsi sendcmd: no error CDB: A1 01 00 00 00 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 24 00 00 00 Sense Key: 0x5 Illegal Request, Segment 0 Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 0.000s timeout 9600s /usr/bin/wodim: Cannot blank disk, aborting. /usr/bin/wodim: Some drives do not support all blank types. /usr/bin/wodim: Try again with wodim blank=all. under Ubuntu 9.04: andr...@alix:~$ /usr/bin/wodim -v gracetime=2 dev=/dev/sr0 speed=4 -tao driveropts=burnfree blank=fast TOC Type: 1 = CD-ROM /usr/bin/wodim: Operation not permitted. Warning: Cannot raise RLIMIT_MEMLOCK limits.scsidev: '/dev/sr0' devname: '/dev/sr0' scsibus: -2 target: -2 lun: -2 Linux sg driver version: 3.5.27 Wodim version: 1.1.9 Driveropts: 'burnfree' SCSI buffer size: 64512 Device type : Removable CD-ROM Version : 0 Response Format: 2 Capabilities : Vendor_info : 'Optiarc ' Identification : 'DVD RW AD-7200A ' Revision : '1.06' Device seems to be: Generic mmc2 DVD-R/DVD-RW. Current: 0x000A (CD-RW) Profile: 0x002B (DVD+R/DL) Profile: 0x001B (DVD+R) Profile: 0x001A (DVD+RW) Profile: 0x0016 (DVD-R/DL layer jump recording) Profile: 0x0015 (DVD-R/DL sequential recording) Profile: 0x0014 (DVD-RW sequential recording) Profile: 0x0013 (DVD-RW restricted overwrite) Profile: 0x0012 (DVD-RAM) Profile: 0x0011 (DVD-R sequential recording) Profile: 0x0010 (DVD-ROM) Profile: 0x000A (CD-RW) (current) Profile: 0x0009 (CD-R) Profile: 0x0008 (CD-ROM) (current) Profile: 0x0002 (Removable disk) Using generic SCSI-3/mmc CD-R/CD-RW driver (mmc_cdr). Driver flags : MMC-3 SWABAUDIO BURNFREE Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R Drive buf size : 866304 = 846 KB Beginning DMA speed test. Set CDR_NODMATEST environment variable if device communication breaks or freezes immediately after that. Current Secsize: 2048 ATIP info from disk: Indicated writing power: 5 Reference speed: 2 Is not unrestricted Is erasable ATIP start of lead in: -11745 (97:25/30) ATIP start of lead out: 359849 (79:59/74) 1T speed low: 0 (reserved val 0) 1T speed high: 4 2T speed low: 0 (reserved val 5) 2T speed high: 0 (reserved val 12) power mult factor: 4 6 recommended erase/write power: 3 A1 values: 02 4C B0 A2 values: 5C D8 36 Disk type: Phase change Manuf. index: 40 Manufacturer: INFODISC Technology Co., Ltd. Speed set to 706 KB/s Starting to write CD/DVD at speed 4.0 in real BLANK mode for single session. Last chance to quit, starting real write in 0 seconds. Operation starts. Performing OPC... Blanking PMA, TOC, pregap Blanking time: 44.019s
-- Cannot erase CD-RW with wodim after upgrading Ubuntu from 9.04 to 9.10 https://bugs.launchpad.net/bugs/514520 You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
