Public bug reported:
In jaunty, after the recent update to kernel 2.6.28-18, wake on lan no
longer works for our machines with intel e1000e chipsets.
Up until 2.6.28-17 this was working fine.
# ethtool -s eth0 wol g
Cannot set new wake-on-lan settings: Operation not supported
not setting wol
# ethtool eth0
Settings for eth0:
Supports Wake-on: d
Wake-on: d
# lspci -vvv
00:19.0 Ethernet controller: Intel Corporation 82567LM-3 Gigabit Network
Connection (rev 02)
Subsystem: Intel Corporation Device 1003
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 2302
Region 0: Memory at d0200000 (32-bit, non-prefetchable) [size=128K]
Region 1: Memory at d0224000 (32-bit, non-prefetchable) [size=4K]
Region 2: I/O ports at e0e0 [size=32]
Capabilities: [c8] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0
Enable+
Address: 00000000fee0300c Data: 41a1
Capabilities: [e0] Vendor Specific Information <?>
** Affects: linux (Ubuntu)
Importance: Undecided
Status: New
--
wake on lan no longer possible with e1000e after upgrade to 2.6.28-18
https://bugs.launchpad.net/bugs/520949
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
