When running the commands (sudo iwconfig wlan0 power on/sudo iwconfig
wlan0 power off) with Natty's default drivers, they complete
successfully without anything being displayed on the screen (I didn't
try iwconfig); however, when I run them with the latest wireless driver,
I get the following outputs:
$ sudo iwconfig wlan0 power off
Error for wireless request "Set Power Management" (8B2C) :
SET failed on device wlan0 ; Operation not supported.
$ sudo iwconfig wlan0 power on
Error for wireless request "Set Power Management" (8B2D) :
GET failed on device wlan0 ; Operation not supported.
$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 Ralink STA ESSID:"BTHomeHub2-M5M3" Nickname:"RT2860STA"
Mode:Managed Frequency=2.452 GHz Access Point: 00:21:04:AA:EE:CA
Bit Rate=54 Mb/s
RTS thr:off Fragment thr:off
Link Quality=85/100 Signal level:-59 dBm Noise level:-83 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I'm not sure how to tell if power saving is on or off, I would guess it
probably isn't on with the new drivers.
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/769504
Title:
RT3090 Internal Wi-fi Stability/Connectivity Issue
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/769504/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
