bump, still no USB nor ethernet on neither 11.04 nor 11.10 on my beagleboard xM Rev C. I tried the newest MLO and u-boot.img from wget http://www.angstrom-distribution.org/demo/beagleboard/ (20-Jan-2012 13:48) without noticeable change.
There is but one error message that repeats: [ 3.254364] hub 1-0:1.0: unable to enumerate USB device on port 2 lsusb shows only two USB hubs. But there are numerous messages about USB that look successful... [[[ [ 0.092712] libata version 3.00 loaded. [ 0.093048] usbcore: registered new interface driver usbfs [ 0.093109] usbcore: registered new interface driver hub [ 0.093261] usbcore: registered new device driver usb [ 0.093872] omap_i2c omap_i2c.1: bus 1 rev4.0 at 2600 kHz [ 0.096374] twl4030: PIH (irq 7) chaining IRQs 368..375 [ 0.096405] twl4030: power (irq 373) chaining IRQs 376..383 [ 0.096832] twl4030: gpio (irq 368) chaining IRQs 384..401 [ 0.099090] print_constraints: VUSB1V5: 1500 mV normal standby [ 0.099487] print_constraints: VUSB1V8: 1800 mV normal standby [ 0.099822] print_constraints: VUSB3V1: 3100 mV normal standby [ 0.101593] twl4030_usb twl4030_usb: Initialized TWL4030 USB module [ 0.102325] print_constraints: VMMC1: 1850 <--> 3150 mV at 3150 mV normal standby [ 0.102722] print_constraints: VDAC: 1800 mV normal standby [ 0.103118] print_constraints: VPLL2: 1800 mV normal standby [ 0.103546] print_constraints: VSIM: 1800 <--> 3000 mV at 1800 mV normal standby [ 0.103851] omap_i2c omap_i2c.3: bus 3 rev4.0 at 100 kHz [ 0.104736] Advanced Linux Sound Architecture Driver Version 1.0.24. [ 0.105346] NetLabel: Initializing [ 0.105346] NetLabel: domain hash size = 128 [ 0.105377] NetLabel: protocols = UNLABELED CIPSOv4 [ 0.105438] NetLabel: unlabeled traffic allowed by default [ 0.105804] Switching to clocksource 32k_counter [ 0.111999] Switched to NOHz mode on CPU #0 [ 0.115325] AppArmor: AppArmor Filesystem Enabled [ 0.125396] musb-hdrc: version 6.0, musb-dma, otg (peripheral+host) [ 0.125518] omap_device: musb-omap2430.-1: new worst case activate latency 0: 30517 [ 0.125579] omap_device: omap_i2c.1: new worst case activate latency 0: 30517 [ 0.126251] omap_device: omap_i2c.1: new worst case deactivate latency 0: 30517 [ 0.128356] musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn) [ 0.128387] musb-hdrc: MHDRC RTL version 1.800 [ 0.128387] musb-hdrc: setup fifo_mode 4 [ 0.128417] musb-hdrc: 28/31 max ep, 16384/16384 memory [ 0.128601] musb-hdrc musb-hdrc: USB OTG mode controller at fa0ab000 using DMA, IRQ 92 [ 0.129119] NET: Registered protocol family 2 [ 0.129455] IP route cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.130218] TCP established hash table entries: 16384 (order: 5, 131072 bytes) [ 0.130584] TCP bind hash table entries: 16384 (order: 4, 65536 bytes) [ 0.130798] TCP: Hash tables configured (established 16384 bind 16384) [ 0.130798] TCP reno registered [ 0.130828] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.130828] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.131256] NET: Registered protocol family 1 [ 0.131317] NetWinder Floating Point Emulator V0.97 (double precision) [ 0.131561] Trying to unpack rootfs image as initramfs... [ 0.138732] PMU: registered new PMU device of type 0 [ 0.139404] audit: initializing netlink socket (disabled) [ 0.139465] type=2000 audit(0.156:1): initialized [ 0.358489] VFS: Disk quotas dquot_6.5.2 [ 0.358795] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 0.371887] fuse init (API version 7.16) [ 0.372619] msgmni has been set to 959 [ 0.380126] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 253) [ 0.380310] io scheduler noop registered (default) [ 0.380340] io scheduler deadline registered [ 0.380432] io scheduler cfq registered [ 0.442260] OMAP DSS rev 2.0 [ 0.451019] Serial: 8250/16550 driver, 32 ports, IRQ sharing enabled [ 0.457275] omap_uart.0: ttyO0 at MMIO 0x4806a000 (irq = 72) is a OMAP UART0 [ 0.465850] omap_uart.1: ttyO1 at MMIO 0x4806c000 (irq = 73) is a OMAP UART1 [ 0.466247] omap_uart.2: ttyO2 at MMIO 0x49020000 (irq = 74) is a OMAP UART2 [ 0.466430] console [ttyO2] enabled [ 0.466705] omap_uart.3: ttyO3 at MMIO 0x49042000 (irq = 80) is a OMAP UART3 [ 0.482910] brd: module loaded [ 0.486511] loop: module loaded [ 0.488372] omap2-nand driver initializing [ 0.488800] No NAND device found. [ 0.489013] No NAND device found. [ 0.490966] Fixed MDIO Bus: probed [ 0.491119] PPP generic driver version 2.4.2 [ 0.491424] SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256) (6 bit encapsulation enabled). [ 0.491455] CSLIP: code copyright 1989 Regents of the University of California. [ 0.491455] SLIP linefill/keepalive option. [ 0.491546] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 2.504333] ehci-omap ehci-omap.0: OMAP-EHCI Host Controller [ 2.971160] Freeing initrd memory: 5704K [ 2.971282] ehci-omap ehci-omap.0: new USB bus registered, assigned bus number 1 [ 2.971405] ehci-omap ehci-omap.0: irq 77, io mem 0x48064800 [ 2.980926] ehci-omap ehci-omap.0: USB 2.0 started, EHCI 1.00 [ 2.981750] hub 1-0:1.0: USB hub found [ 2.981781] hub 1-0:1.0: 3 ports detected [ 3.012207] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver [ 3.012359] ohci-omap3 ohci-omap3.0: OMAP3 OHCI Host Controller [ 3.012390] ohci-omap3 ohci-omap3.0: new USB bus registered, assigned bus number 2 [ 3.012481] ohci-omap3 ohci-omap3.0: irq 76, io mem 0x48064400 [ 3.092285] hub 2-0:1.0: USB hub found [ 3.092315] hub 2-0:1.0: 3 ports detected [ 3.093109] mousedev: PS/2 mouse device common for all mice [ 3.094482] twl_rtc twl_rtc: rtc core: registered twl_rtc as rtc0 [ 3.094604] twl_rtc twl_rtc: Power up reset detected. [ 3.094909] twl_rtc twl_rtc: Enabling TWL-RTC. [ 3.095855] device-mapper: uevent: version 1.0.3 [ 3.096374] device-mapper: ioctl: 4.20.0-ioctl (2011-02-02) initialised: [email protected] [ 3.096405] cpuidle: using governor ladder [ 3.096435] cpuidle: using governor menu [ 3.096496] sdhci: Secure Digital Host Controller Interface driver [ 3.096496] sdhci: Copyright(c) Pierre Ossman [ 3.209533] OMAP3 Beagle/Devkit8000 SoC init [ 3.254364] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 3.296203] asoc: twl4030-hifi <-> omap-mcbsp-dai.1 mapping ok [ 3.296966] ALSA device list: [ 3.296997] #0: omap3beagle [ 3.298095] TCP cubic registered [ 3.299255] NET: Registered protocol family 10 [ 3.301635] NET: Registered protocol family 17 [ 3.301849] Registering the dns_resolver key type [ 3.301910] VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 3 [ 3.304779] clock: disabling unused clocks to save power [ 3.305633] registered taskstats version 1 [ 3.305847] fbcvt: 1280x720@60: CVT Name - .921M9-R [ 3.326202] Console: switching to colour frame buffer device 160x45 [ 3.339447] regulator_init_complete: VDAC: incomplete constraints, leaving on [ 3.341247] twl_rtc twl_rtc: setting system clock to 2000-01-01 00:00:00 UTC (946684800) [ 3.341735] Freeing init memory: 256K [ 3.473327] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 3.482177] udevd[62]: starting version 173 [ 3.692077] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 3.797210] mmc0: host does not support reading read-only switch. assuming write-enable. [ 3.809326] mmc0: new SDHC card at address 1234 [ 3.817077] mmcblk0: mmc0:1234 SA04G 3.70 GiB [ 3.820495] mmcblk0: p1 p2 [ 3.910827] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 4.129547] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 4.348297] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 4.567047] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 4.785797] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 5.004608] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 5.223327] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 5.442077] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 5.553802] Btrfs loaded [ 5.684234] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 5.843963] EXT4-fs (mmcblk0p2): mounted filesystem with ordered data mode. Opts: (null) [ 5.903106] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 6.121734] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 6.340301] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 6.559082] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 6.777954] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 6.996643] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 7.215545] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 7.434234] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 7.652801] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 7.871734] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 8.102722] hub 1-0:1.0: unable to enumerate USB device on port 2 [ 8.210723] udevd[276]: starting version 173 [ 8.711944] input: gpio-keys as /devices/platform/gpio-keys/input/input0 [ 8.720458] Registered led device: beagleboard::usr0 ]]] -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/871650 Title: "unable to enumerate USB device" with BeagleBoard-xM To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/linux/+bug/871650/+subscriptions -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
