Hi Stephen Many thanks for the email. I did copy the correct file over from my win 2000 system and you probably missed that sane worked once and the scanner scanned and I was happy. However after a reboot it has never worked again. I have almost forgotten about it. I'll have another go and let you know. Regards Peter ----- Original Message ----- From: "Stephen Anthony" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, June 05, 2007 6:42 AM Subject: [Bug 24946] Re: Detected scanner fails to load with "Invalid Argument"
The same problem continues to exist in Feisty (7.04) with 2.6.20-16-generic, which still uses libusb-0.1.4 While I can only verify it for my system, I followed the directions at http://www.sane-project.org/man/sane-artec_eplus48u.5.html, copying the firmware file over from the cd (the WinXP file), and I can now scan 16-bit 1200 dpi color. No other changes were necessary. (Helpful hint: all initial settings in xsane were correct, except that it was set to scan only a 5 cm square. Correct that, and xsane works fine after doing the above.) -- Detected scanner fails to load with "Invalid Argument" https://bugs.launchpad.net/bugs/24946 You received this bug notification because you are a direct subscriber of the bug. -- Detected scanner fails to load with "Invalid Argument" https://bugs.launchpad.net/bugs/24946 You received this bug notification because you are a member of Ubuntu Bugs, which is a direct subscriber. -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
