Same for me with 02:00.0 Network controller: Intel Corporation Centrino
Advanced-N 6200 (rev 35)
root@scrat:~# iw list
Wiphy phy1
Band 1:
Capabilities: 0x872
HT20/HT40
Static SM Power Save
RX Greenfield
RX HT20 SGI
RX HT40 SGI
No RX STBC
Max AMSDU length: 7935 bytes
No DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 4 usec (0x05)
HT TX/RX MCS rate indexes supported: 0-15, 32
Frequencies:
* 2412 MHz [1] (15.0 dBm)
* 2417 MHz [2] (15.0 dBm)
* 2422 MHz [3] (15.0 dBm)
* 2427 MHz [4] (15.0 dBm)
* 2432 MHz [5] (15.0 dBm)
* 2437 MHz [6] (15.0 dBm)
* 2442 MHz [7] (15.0 dBm)
* 2447 MHz [8] (15.0 dBm)
* 2452 MHz [9] (15.0 dBm)
* 2457 MHz [10] (15.0 dBm)
* 2462 MHz [11] (15.0 dBm)
* 2467 MHz [12] (15.0 dBm) (passive scanning, no IBSS)
* 2472 MHz [13] (15.0 dBm) (passive scanning, no IBSS)
Bitrates (non-HT):
* 1.0 Mbps
* 2.0 Mbps (short preamble supported)
* 5.5 Mbps (short preamble supported)
* 11.0 Mbps (short preamble supported)
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
Band 2:
Capabilities: 0x872
HT20/HT40
Static SM Power Save
RX Greenfield
RX HT20 SGI
RX HT40 SGI
No RX STBC
Max AMSDU length: 7935 bytes
No DSSS/CCK HT40
Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Minimum RX AMPDU time spacing: 4 usec (0x05)
HT TX/RX MCS rate indexes supported: 0-15, 32
Frequencies:
* 5180 MHz [36] (15.0 dBm) (passive scanning, no IBSS)
* 5200 MHz [40] (15.0 dBm) (passive scanning, no IBSS)
* 5220 MHz [44] (15.0 dBm) (passive scanning, no IBSS)
* 5240 MHz [48] (15.0 dBm) (passive scanning, no IBSS)
* 5260 MHz [52] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5280 MHz [56] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5300 MHz [60] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5320 MHz [64] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5500 MHz [100] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5520 MHz [104] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5540 MHz [108] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5560 MHz [112] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5580 MHz [116] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5600 MHz [120] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5620 MHz [124] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5640 MHz [128] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5660 MHz [132] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5680 MHz [136] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5700 MHz [140] (15.0 dBm) (passive scanning, no IBSS,
radar detection)
* 5745 MHz [149] (15.0 dBm) (passive scanning, no IBSS)
* 5765 MHz [153] (15.0 dBm) (passive scanning, no IBSS)
* 5785 MHz [157] (15.0 dBm) (passive scanning, no IBSS)
* 5805 MHz [161] (15.0 dBm) (passive scanning, no IBSS)
* 5825 MHz [165] (15.0 dBm) (passive scanning, no IBSS)
Bitrates (non-HT):
* 6.0 Mbps
* 9.0 Mbps
* 12.0 Mbps
* 18.0 Mbps
* 24.0 Mbps
* 36.0 Mbps
* 48.0 Mbps
* 54.0 Mbps
max # scan SSIDs: 20
max scan IEs length: 127 bytes
Coverage class: 0 (up to 0m)
Supported Ciphers:
* WEP40 (00-0f-ac:1)
* WEP104 (00-0f-ac:5)
* TKIP (00-0f-ac:2)
* CCMP (00-0f-ac:4)
Available Antennas: TX 0 RX 0
Supported interface modes:
* IBSS
* managed
* monitor
software interface modes (can always be added):
* monitor
interface combinations are not supported
Supported commands:
* new_interface
* set_interface
* new_key
* new_beacon
* new_station
* new_mpath
* set_mesh_params
* set_bss
* authenticate
* associate
* deauthenticate
* disassociate
* join_ibss
* join_mesh
* remain_on_channel
* set_tx_bitrate_mask
* action
* frame_wait_cancel
* set_wiphy_netns
* set_channel
* set_wds_peer
* connect
* disconnect
Supported TX frame types:
* IBSS: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* managed: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* AP: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060 0x0070
0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* AP/VLAN: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* mesh point: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* P2P-client: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
* P2P-GO: 0x0000 0x0010 0x0020 0x0030 0x0040 0x0050 0x0060
0x0070 0x0080 0x0090 0x00a0 0x00b0 0x00c0 0x00d0 0x00e0 0x00f0
Supported RX frame types:
* IBSS: 0x00d0
* managed: 0x0040 0x00d0
* AP: 0x0000 0x0020 0x0040 0x00a0 0x00b0 0x00c0 0x00d0
* AP/VLAN: 0x0000 0x0020 0x0040 0x00a0 0x00b0 0x00c0 0x00d0
* mesh point: 0x00b0 0x00c0 0x00d0
* P2P-client: 0x0040 0x00d0
* P2P-GO: 0x0000 0x0020 0x0040 0x00a0 0x00b0 0x00c0 0x00d0
Device supports RSN-IBSS.
Asking password on channel 13 again and again and again....
I can confirm with another card - a RT2800usb - that dont worked on
Precise but worked well in Oneiric.
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/931168
Title:
brcm80211 Wifi driver : cannot connect to channels>11
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux/+bug/931168/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
