Hi,
it's working again on my laptop!
Using a wep 64 wifi network and a WG511v1.
[ 23.956000] Loaded prism54 driver, version 1.2
[ 23.956000] PCI: Enabling device 0000:03:00.0 (0000 -> 0002)
[ 23.956000] ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [C0C4] -> GSI 11
(level, low) -> IRQ 11
[ 23.956000] prism54: pci_set_mwi(pdev) succeeded
...
[ 38.288000] eth5: resetting device...
[ 38.288000] eth5: uploading firmware...
[ 38.540000] eth5: firmware version: 1.0.4.3
[ 38.540000] eth5: firmware upload complete
[ 38.772000] eth5: interface reset complete
eth5 IEEE 802.11b/g ESSID:"xxx"
Mode:Managed Frequency:2.422 GHz Access Point: xx:xx:xx....
Bit Rate:24 Mb/s Tx-Power=31 dBm Sensitivity=20/200
Retry short limit:8 RTS thr=2347 B Fragment thr=2346 B
Link Quality=156/0 Signal level=-73 dBm Noise level=-223 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Thank you very much!
--
no prism54 driver in gutsy
https://bugs.launchpad.net/bugs/129537
You received this bug notification because you are a member of Ubuntu
Bugs, which is the bug contact for Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
