Hi there, as a new kernel is out I was coming to give You an update, and
here it is; thank You for pointing me to
https://bugs.launchpad.net/bugs/139070 but the stick I'm talking about
is an rt25 card not an rt73 one. So, new kernel, same behaviour, here it
is the details:
[EMAIL PROTECTED]:~$ uname -rvm
2.6.22-13-generic #1 SMP Thu Oct 4 17:18:44 GMT 2007 i686
dmesg output: what is this wmaster0 thing?
---snip---
[ 47.551086] usbcore: registered new interface driver hci_usb
[ 47.922760] ieee80211_init: failed to initialize WME (err=-17)
[ 47.935668] iwlwifi_rc80211_simple: Unknown symbol
iwlwifi_ieee80211_rate_control_unregister
[ 47.935710] iwlwifi_rc80211_simple: Unknown symbol iwlwifi_sta_info_put
[ 47.935745] iwlwifi_rc80211_simple: Unknown symbol iwlwifi_sta_info_get
[ 47.935799] iwlwifi_rc80211_simple: Unknown symbol
iwlwifi_ieee80211_rate_control_register
[ 47.948378] wmaster0: Selected rate control algorithm 'simple'
[ 48.002202] usbcore: registered new interface driver rt2500usb
[ 48.054484] PCI: Setting latency timer of device 0000:00:11.6 to 64
[ 48.371347] NET: Registered protocol family 10
[ 48.371464] lo: Disabled Privacy Extensions
[ 48.371539] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 48.371580] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[ 48.558119] ACPI: PCI interrupt for device 0000:00:11.6 disabled
[ 48.558136] VIA 82xx Modem: probe of 0000:00:11.6 failed with error -13
[ 48.558410] ACPI: PCI Interrupt 0000:00:11.5[C] -> GSI 22 (level, low) ->
IRQ 19
[ 48.558553] PCI: Setting latency timer of device 0000:00:11.5 to 64
[ 48.865372] wlan0: Initial auth_alg=0
[ 48.865379] wlan0: authenticate with AP 00:14:c1:1f:1f:e0
[ 48.867136] wlan0: RX authentication from 00:14:c1:1f:1f:e0 (alg=0
transaction=2 status=0)
[ 48.867139] wlan0: authenticated
[ 48.867142] wlan0: associate with AP 00:14:c1:1f:1f:e0
[ 48.869374] wlan0: RX AssocResp from 00:14:c1:1f:1f:e0 (capab=0x411 status=0
aid=1)
[ 48.869378] wlan0: associated
[ 48.870416] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 49.071708] codec_read: codec 0 is not valid [0xfe0000]
[ 49.077951] codec_read: codec 0 is not valid [0xfe0000]
[ 49.084236] codec_read: codec 0 is not valid [0xfe0000]
[ 49.090480] codec_read: codec 0 is not valid [0xfe0000]
[ 49.433469] wlan0: duplicate address detected!
---snip---
lsusb output, do not bother with the Broadcom device as it is a bluetooth
dongle:
[EMAIL PROTECTED]:~$ lsusb
Bus 005 Device 002: ID 04b4:6560 Cypress Semiconductor Corp. CY7C65640 USB-2.0
"TetraHub"
Bus 005 Device 001: ID 0000:0000
Bus 005 Device 004: ID 0b05:1706 ASUSTek Computer, Inc.
Bus 001 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 002: ID 0a5c:2101 Broadcom Corp.
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
according to Asus:
0B05:1706 rt25USB
0B05:1707 rt25USB
0B05:1723 rt73
0B05:1724 rt73
a couple of sifted lsusb outputs:
[EMAIL PROTECTED]:~$ lsmod |grep rt2
rt2500usb 22016 0
rt2x00usb 12032 1 rt2500usb
rt2x00lib 19584 2 rt2500usb,rt2x00usb
rfkill 8208 1 rt2x00lib
mac80211 171016 3 rc80211_simple,rt2x00usb,rt2x00lib
input_polldev 5896 1 rt2x00lib
crc_itu_t 3072 1 rt2x00lib
usbcore 138248 6 rt2500usb,rt2x00usb,hci_usb,ehci_hcd,uhci_hcd
[EMAIL PROTECTED]:~$ lsmod |grep 80211
rc80211_simple 6912 1
mac80211 171016 3 rc80211_simple,rt2x00usb,rt2x00lib
cfg80211 7304 1 mac80211
iwconfig output:
[EMAIL PROTECTED]:~$ iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wmaster0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:"c4s4"
Mode:Managed Frequency:2.437 GHz Access Point: 00:14:C1:1F:1F:E0
Retry min limit:7 RTS thr:off Fragment thr=2346 B
Link Signal level=-59 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ifconfig output:
[EMAIL PROTECTED]:~$ ifconfig
eth0 Link encap:Ethernet HWaddr 00:0C:6E:9C:B7:91
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:16
eth0:avah Link encap:Ethernet HWaddr 00:0C:6E:9C:B7:91
inet addr:169.254.8.110 Bcast:169.254.255.255 Mask:255.255.0.0
UP BROADCAST MULTICAST MTU:1500 Metric:1
Interrupt:16
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:219 errors:0 dropped:0 overruns:0 frame:0
TX packets:219 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:19073 (18.6 KB) TX bytes:19073 (18.6 KB)
wlan0 Link encap:Ethernet HWaddr 00:11:D8:DF:79:13
inet addr:192.168.1.13 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::211:d8ff:fedf:7913/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:23 errors:0 dropped:0 overruns:0 frame:0
TX packets:301 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3903 (3.8 KB) TX bytes:25409 (24.8 KB)
wmaster0 Link encap:UNSPEC HWaddr
00-11-D8-DF-79-13-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
and still the stick does not work; this is it! Hope the info is of some
use. Next I'm going to do some tests compiling modules downloaded from
the internet and I'll let You know what the outcome is. FYI the fedora
kernel driving this card beautifully is release 2.6.22.9-91.fc7, also
the 2.6.23 kernel from the fedora development version works well with
this card. As for the serialmonkey rt2570 cvs the last I've tried was
rt2570-cvs-2007092413.
--
rt2500usb module not working with asus wl-167g wifi stick
https://bugs.launchpad.net/bugs/144448
You received this bug notification because you are a member of Ubuntu
Bugs, which is the bug contact for Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
