Public bug reported:
After going into suspend (via command line or lid close), the MacBook
Pro (early 2015) wakes up immediately again. Same for hibernation.
Running Ubuntu 18.04.
extract from dmesg for a lid-close -> suspend -> wake-up -> lid-open
cycle:
[ 0.000000] Linux version 4.15.0-22-generic (buildd@lgw01-amd64-013) (gcc
version 7.3.0 (Ubuntu 7.3.0-16ubuntu3)) #24-Ubuntu SMP Wed May 16 12:15:17 UTC
2018 (Ubuntu 4.15.0-22.24-generic 4.15.17)
[ ... ]
[ 778.968982] brcmfmac: brcmf_inetaddr_changed: fail to get arp ip table
err:-23
[ 783.011399] PM: suspend entry (deep)
[ 783.011400] PM: Syncing filesystems ... done.
[ 783.028538] Freezing user space processes ... (elapsed 0.002 seconds) done.
[ 783.030844] OOM killer disabled.
[ 783.030844] Freezing remaining freezable tasks ... (elapsed 0.001 seconds)
done.
[ 783.032193] Suspending console(s) (use no_console_suspend to debug)
[ 783.049960] sd 1:0:0:0: [sda] Synchronizing SCSI cache
[ 783.054107] sd 1:0:0:0: [sda] Stopping disk
[ 783.146124] thunderbolt 0000:07:00.0: suspending...
[ 783.146685] thunderbolt 0000:07:00.0: suspend finished
[ 783.146689] thunderbolt 0000:07:00.0: stopping RX ring 0
[ 783.146698] thunderbolt 0000:07:00.0: disabling interrupt at register
0x38200 bit 12 (0x1001 -> 0x1)
[ 783.146710] thunderbolt 0000:07:00.0: stopping TX ring 0
[ 783.146718] thunderbolt 0000:07:00.0: disabling interrupt at register
0x38200 bit 0 (0x1 -> 0x0)
[ 783.146725] thunderbolt 0000:07:00.0: control channel stopped
[ 783.246464] ACPI: Preparing to enter system sleep state S3
[ 783.418015] ACPI: EC: event blocked
[ 783.418016] ACPI: EC: EC stopped
[ 783.418018] PM: Saving platform NVS memory
[ 783.418027] Disabling non-boot CPUs ...
[ 783.434574] IRQ 65: no longer affine to CPU1
[ 783.435629] smpboot: CPU 1 is now offline
[ 783.454574] IRQ 66: no longer affine to CPU2
[ 783.456378] smpboot: CPU 2 is now offline
[ 783.478405] IRQ 21: no longer affine to CPU3
[ 783.478414] IRQ 43: no longer affine to CPU3
[ 783.478435] IRQ 71: no longer affine to CPU3
[ 783.479449] smpboot: CPU 3 is now offline
[ 783.481656] ACPI: Low-level resume complete
[ 783.481733] ACPI: EC: EC started
[ 783.481734] PM: Restoring platform NVS memory
[ 783.482160] Enabling non-boot CPUs ...
[ 783.482240] x86: Booting SMP configuration:
[ 783.482241] smpboot: Booting Node 0 Processor 1 APIC 0x2
[ 783.558589] cache: parent cpu1 should not be sleeping
[ 783.687159] CPU1 is up
[ 783.687212] smpboot: Booting Node 0 Processor 2 APIC 0x1
[ 783.687812] cache: parent cpu2 should not be sleeping
[ 783.688001] CPU2 is up
[ 783.688028] smpboot: Booting Node 0 Processor 3 APIC 0x3
[ 783.783709] cache: parent cpu3 should not be sleeping
[ 783.978233] CPU3 is up
[ 783.982020] ACPI: Waking up from system sleep state S3
[ 784.093246] pcieport 0000:06:03.0: quirk: waiting for thunderbolt to
reestablish PCI tunnels...
[ 784.093249] pcieport 0000:06:04.0: quirk: waiting for thunderbolt to
reestablish PCI tunnels...
[ 784.093362] pcieport 0000:06:06.0: quirk: waiting for thunderbolt to
reestablish PCI tunnels...
[ 784.093475] pcieport 0000:06:05.0: quirk: waiting for thunderbolt to
reestablish PCI tunnels...
[ 784.112655] thunderbolt 0000:07:00.0: control channel starting...
[ 784.112660] thunderbolt 0000:07:00.0: starting TX ring 0
[ 784.112673] thunderbolt 0000:07:00.0: enabling interrupt at register 0x38200
bit 0 (0x0 -> 0x1)
[ 784.112677] thunderbolt 0000:07:00.0: starting RX ring 0
[ 784.112689] thunderbolt 0000:07:00.0: enabling interrupt at register 0x38200
bit 12 (0x1 -> 0x1001)
[ 784.112696] thunderbolt 0000:07:00.0: resuming...
[ 784.112699] thunderbolt 0000:07:00.0: resetting switch at 0
[ 784.113249] thunderbolt 0000:07:00.0: 0: resuming switch
[ 784.144609] thunderbolt 0000:07:00.0: resume finished
[ 784.213878] thunderbolt 0000:07:00.0: resetting error on 0:b.
[ 784.213897] thunderbolt 0000:07:00.0: 0:b: hotplug: scanning
[ 784.213901] thunderbolt 0000:07:00.0: 0:b: hotplug: no switch found
[ 784.213984] thunderbolt 0000:07:00.0: resetting error on 0:c.
[ 784.213995] thunderbolt 0000:07:00.0: 0:c: hotplug: scanning
[ 784.213999] thunderbolt 0000:07:00.0: 0:c: hotplug: no switch found
[ 785.225640] ACPI: EC: event unblocked
[ 785.226264] brcmfmac: brcmf_fil_cmd_data: bus is down. we have nothing to do.
[ 785.226273] ACPI: button: The lid device is not compliant to SW_LID.
[ 785.226276] brcmfmac: brcmf_fil_cmd_data: bus is down. we have nothing to do.
[ 785.227145] brcmfmac: brcmf_fil_cmd_data: bus is down. we have nothing to do.
[ 785.227149] brcmfmac: brcmf_cfg80211_get_channel: chanspec failed (-5)
[ 785.236199] sd 1:0:0:0: [sda] Starting disk
[ 785.408582] brcmfmac: brcmf_fw_map_chip_to_name: using
brcm/brcmfmac43602-pcie.bin for chip 0x00aa52(43602) rev 0x000001
[ 785.408703] brcmfmac 0000:03:00.0: Direct firmware load for
brcm/brcmfmac43602-pcie.txt failed with error -2
[ 785.409666] OOM killer enabled.
[ 785.409669] Restarting tasks ... done.
[ 785.512763] PM: suspend exit
[ 785.551234] ata1: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[ 785.551556] ata1.00: unexpected _GTF length (8)
[ 785.551932] ata1.00: unexpected _GTF length (8)
[ 785.552117] ata1.00: configured for UDMA/133
[ 785.920424] brcmfmac 0000:03:00.0: Direct firmware load for
brcm/brcmfmac43602-pcie.clm_blob failed with error -2
[ 785.920432] brcmfmac: brcmf_c_process_clm_blob: no clm_blob
available(err=-2), device may have limited channels available
[ 785.921076] brcmfmac: brcmf_c_preinit_dcmds: Firmware version = wl0: Nov 10
2015 06:38:10 version 7.35.177.61 (r598657) FWID 01-ea662a8c
[ 785.981088] brcmfmac 0000:03:00.0 wlp3s0: renamed from wlan0
[ 786.015451] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 786.058114] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 786.164061] xhci_hcd 0000:00:14.0: Cannot set link state.
[ 786.164066] usb usb2-port3: cannot disable (err = -32)
[ 786.166116] IPv6: ADDRCONF(NETDEV_UP): wlp3s0: link is not ready
[ 787.756169] xhci_hcd 0000:00:14.0: Cannot set link state.
[ 787.756181] usb usb2-port3: cannot disable (err = -32)
[ 787.756262] xhci_hcd 0000:00:14.0: Cannot set link state.
[ 787.756270] usb usb2-port3: cannot disable (err = -32)
[ 791.512920] IPv6: ADDRCONF(NETDEV_CHANGE): wlp3s0: link becomes ready
[ 791.574858] brcmfmac: brcmf_inetaddr_changed: fail to get arp ip table
err:-23
ProblemType: Bug
DistroRelease: Ubuntu 18.04
Package: linux-image-4.15.0-22-generic 4.15.0-22.24
ProcVersionSignature: Ubuntu 4.15.0-22.24-generic 4.15.17
Uname: Linux 4.15.0-22-generic x86_64
ApportVersion: 2.20.9-0ubuntu7.1
Architecture: amd64
CurrentDesktop: ubuntu:GNOME
Date: Mon Jun 4 15:04:08 2018
InstallationDate: Installed on 2018-06-01 (2 days ago)
InstallationMedia: Ubuntu 18.04 LTS "Bionic Beaver" - Release amd64 (20180426)
SourcePackage: linux-signed
UpgradeStatus: No upgrade log present (probably fresh install)
** Affects: linux-signed (Ubuntu)
Importance: Undecided
Status: New
** Tags: amd64 apport-bug bionic
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1774994
Title:
Laptop wakes up immediately after suspend or hibernation
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux-signed/+bug/1774994/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
