ubuntenok@ubuntenok-HP-250-G6-Notebook-PC:~$ lsblk
NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINT
loop0 7:0 0 149,9M 1 loop /snap/gnome-3-28-1804/71
loop1 7:1 0 42,8M 1 loop /snap/gtk-common-themes/1313
loop2 7:2 0 4M 1 loop /snap/gnome-calculator/406
loop3 7:3 0 54,4M 1 loop /snap/core18/1074
loop4 7:4 0 14,8M 1 loop /snap/gnome-characters/296
loop5 7:5 0 164,4M 1 loop /snap/epiphany/53
loop6 7:6 0 1008K 1 loop /snap/gnome-logs/61
loop7 7:7 0 88,7M 1 loop /snap/core/7396
loop8 7:8 0 149,7M 1 loop /snap/chromium/821
loop9 7:9 0 3,7M 1 loop /snap/gnome-system-monitor/100
loop10 7:10 0 149,8M 1 loop /snap/chromium/849
loop11 7:11 0 14,8M 1 loop /snap/gnome-characters/317
sda 8:0 0 119,2G 0 disk
└─sda1 8:1 0 119,2G 0 part /
ubuntenok@ubuntenok-HP-250-G6-Notebook-PC:~$ sudo hdparm -I /dev/sda
[sudo] пароль для ubuntenok:
/dev/sda:
ATA device, with non-removable media
Model Number: SAMSUNG MZNLN128HAHQ-000H1
Serial Number: S3T8NF0K637003
Firmware Revision: MVT23H3Q
Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions,
SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
Standards:
Used: unknown (minor revision code 0x0039)
Supported: 10 9 8 7 6 5
Likely used: 10
Configuration:
Logical max current
cylinders 16383 0
heads 16 0
sectors/track 63 0
--
LBA user addressable sectors: 250069680
LBA48 user addressable sectors: 250069680
Logical Sector size: 512 bytes
Physical Sector size: 4096 bytes
Logical Sector-0 offset: 0 bytes
device size with M = 1024*1024: 122104 MBytes
device size with M = 1000*1000: 128035 MBytes (128 GB)
cache/buffer size = unknown
Form Factor: unknown (0x0007]
Nominal Media Rotation Rate: Solid State Device
Capabilities:
LBA, IORDY(can be disabled)
Queue depth: 32
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 16
Advanced power management level: disabled
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=120ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* SMART feature set
Security Mode feature set
* Power Management feature set
* Write cache
* Look-ahead
* WRITE_BUFFER command
* READ_BUFFER command
* NOP cmd
* DOWNLOAD_MICROCODE
Advanced Power Management feature set
* 48-bit Address feature set
* Mandatory FLUSH_CACHE
* FLUSH_CACHE_EXT
* SMART error logging
* SMART self-test
* General Purpose Logging feature set
* 64-bit World wide name
* IDLE_IMMEDIATE with UNLOAD
* WRITE_UNCORRECTABLE_EXT command
* {READ,WRITE}_DMA_EXT_GPL commands
* Segmented DOWNLOAD_MICROCODE
* unknown 119[6]
unknown 119[8]
unknown 119[9]
* Gen1 signaling speed (1.5Gb/s)
* Gen2 signaling speed (3.0Gb/s)
* Gen3 signaling speed (6.0Gb/s)
* Native Command Queueing (NCQ)
* Phy event counters
* READ_LOG_DMA_EXT equivalent to READ_LOG_EXT
* DMA Setup Auto-Activate optimization
* Device-initiated interface power management
Asynchronous notification (eg. media change)
* Software settings preservation
unknown 78[7]
Device Sleep (DEVSLP)
* SMART Command Transport (SCT) feature set
* SCT Write Same (AC2)
* SCT Error Recovery Control (AC3)
* SCT Features Control (AC4)
* SCT Data Tables (AC5)
* SANITIZE_ANTIFREEZE_LOCK_EXT command
* SANITIZE feature set
* CRYPTO_SCRAMBLE_EXT command
* BLOCK_ERASE_EXT command
* reserved 69[3]
* DOWNLOAD MICROCODE DMA command
* WRITE BUFFER DMA command
* READ BUFFER DMA command
* Data Set Management TRIM supported (limit 8 blocks)
* Deterministic read ZEROs after TRIM
Security:
Master password revision code = 65534
supported
not enabled
not locked
not frozen
not expired: security count
supported: enhanced erase
2min for SECURITY ERASE UNIT. 8min for ENHANCED SECURITY ERASE UNIT.
Logical Unit WWN Device Identifier: 5002538d42b7181c
NAA : 5
IEEE OUI : 002538
Unique ID : d42b7181c
Device Sleep:
DEVSLP Exit Timeout (DETO): 50 ms (drive)
Minimum DEVSLP Assertion Time (MDAT): 30 ms (drive)
Checksum: correct
ubuntenok@ubuntenok-HP-250-G6-Notebook-PC:~$
--
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/1831369
Title:
Gnome Shell pauses and stutters while waiting (several seconds) for
programs to launch
To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/gnome-shell/+bug/1831369/+subscriptions
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
