I have been using rc6 kernel 5.10, plus I git cloned the ath11k-firmware repo, and linking /lib/firmware/ath11k/QCA6390/hw2.0 -> /lib/ath11k- firmware/QCA6390/hw2.0/1.0.1/WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1/
uname -a: Linux minty 5.10.0-051000rc6-generic #202011291930 SMP Mon Nov 30 00:36:46 UTC 2020 x86_64 x86_64 x86_64 GNU/Linux I have had pretty good results with the wifi, except that after sleep resume, i always have to do sudo modprobe -r -f ath11k_pci && sudo modprobe ath11k_pci -- which takes 2 to 3 minutes (last run - 2:34). Otherwise wifi is not working at all. Additionally, on occasion I have observed full system lock ups that require hard reboot (long press on power button). I do not know if this is related. [ +0.000006] usb 1-3.1: USB disconnect, device number 6 [ +0.219827] usb 1-3.2: USB disconnect, device number 5 [ +0.150986] pcieport 0000:00:1c.4: PME: Spurious native interrupt! [ +1.140384] ACPI Error: Thread 2487681024 cannot release Mutex [ECMX] acquired by thread 1375698944 (20200925/exmutex-378) [ +0.000019] No Local Variables are initialized for Method [_Q66] [ +0.000003] No Arguments are initialized for method [_Q66] [ +0.000007] ACPI Error: Aborting method \_SB.PCI0.LPCB.ECDV._Q66 due to previous error (AE_AML_NOT_OWNER) (20200925/psparse-529) [ +0.079962] usb 6-1: USB disconnect, device number 2 [ +1.614174] wlp4s0: deauthenticating from 58:ef:68:0f:2a:3a by local choice (Reason: 3=DEAUTH_LEAVING) [ +0.140469] PM: suspend entry (s2idle) [ +0.009589] Filesystems sync: 0.009 seconds [ +0.002797] Freezing user space processes ... (elapsed 0.060 seconds) done. [ +0.060942] OOM killer disabled. [ +0.000001] Freezing remaining freezable tasks ... (elapsed 0.001 seconds) done. [ +0.001721] printk: Suspending console(s) (use no_console_suspend to debug) [Dec19 20:21] ACPI: EC: interrupt blocked [Dec19 20:34] ACPI: EC: interrupt unblocked [ +1.399994] xhci_hcd 0000:a5:00.0: BAR 0: error updating (0x8af00000 != 0x000000) [ +0.189078] nvme nvme0: 16/0/0 default/read/poll queues [ +0.304973] OOM killer enabled. [ +0.000001] Restarting tasks ... [ +0.003223] mei_hdcp 0000:00:16.0-b638ab7e-94e2-4ea2-a552-d1c54b627f04: bound 0000:00:02.0 (ops i915_hdcp_component_ops [i915]) [ +0.004528] done. [ +0.063481] PM: suspend exit [ +3.018443] ath11k_pci 0000:04:00.0: wmi command 16387 timeout [ +0.000027] ath11k_pci 0000:04:00.0: failed to send WMI_PDEV_SET_PARAM cmd [ +0.000006] ath11k_pci 0000:04:00.0: failed to enable dynamic bw: -11 [ +3.071691] ath11k_pci 0000:04:00.0: wmi command 16387 timeout [ +0.000003] ath11k_pci 0000:04:00.0: failed to send WMI_PDEV_SET_PARAM cmd [ +0.000003] ath11k_pci 0000:04:00.0: failed to enable PMF QOS: (-11 [ +3.071750] ath11k_pci 0000:04:00.0: wmi command 16387 timeout [ +0.000005] ath11k_pci 0000:04:00.0: failed to send WMI_PDEV_SET_PARAM cmd [ +0.000005] ath11k_pci 0000:04:00.0: failed to enable PMF QOS: (-11 [ +13.566946] ath11k_pci 0000:04:00.0: wmi command 16387 timeout [ +0.000007] ath11k_pci 0000:04:00.0: failed to send WMI_PDEV_SET_PARAM cmd [ +0.000006] ath11k_pci 0000:04:00.0: failed to enable PMF QOS: (-11 [ +0.144494] failed to send QMI message [ +0.000007] ath11k_pci 0000:04:00.0: qmi failed to send mode request, mode: 4, err = -5 [ +0.000001] ath11k_pci 0000:04:00.0: qmi failed to send wlan mode off [Dec19 20:37] cfg80211: Loading compiled-in X.509 certificates for regulatory database [ +0.000191] cfg80211: Loaded X.509 cert 'sforshee: 00b28ddf47aef9cea7' [ +0.017076] ath11k_pci 0000:04:00.0: WARNING: ath11k PCI support is experimental! [ +0.000153] ath11k_pci 0000:04:00.0: BAR 0: assigned [mem 0xd2100000-0xd21fffff 64bit] [ +0.070957] mhi 0000:04:00.0: Requested to power ON [ +0.000207] mhi 0000:04:00.0: Power on setup success [ +0.414557] ath11k_pci 0000:04:00.0: Respond mem req failed, result: 1, err: 0 [ +0.000006] ath11k_pci 0000:04:00.0: qmi failed to respond fw mem req:-22 [ +0.010392] ath11k_pci 0000:04:00.0: chip_id 0x0 chip_family 0xb board_id 0xff soc_id 0xffffffff [ +0.000005] ath11k_pci 0000:04:00.0: fw_version 0x101c06cc fw_build_timestamp 2020-06-24 19:50 fw_build_id [ +0.204570] ath11k_pci 0000:04:00.0 wlp4s0: renamed from wlan0 [Dec19 20:38] wlp4s0: authenticate with 58:ef:68:0f:2a:3a [ +0.149049] wlp4s0: send auth to 58:ef:68:0f:2a:3a (try 1/3) [ +0.005101] wlp4s0: authenticated [ +0.000015] ath11k_pci 0000:04:00.0 wlp4s0: disabling HT/VHT/HE due to WEP/TKIP use [ +0.007783] wlp4s0: associate with 58:ef:68:0f:2a:3a (try 1/3) [ +0.019239] wlp4s0: RX AssocResp from 58:ef:68:0f:2a:3a (capab=0x11 status=0 aid=3) [ +0.015076] wlp4s0: associated [ +0.007314] IPv6: ADDRCONF(NETDEV_CHANGE): wlp4s0: link becomes ready [Dec19 20:39] perf: interrupt took too long (4034 > 4022), lowering kernel.perf_event_max_sample_rate to 49500 -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/1879633 Title: Killer 500s (QCA6390) WLAN/BT [17cb:1101] unavailable To manage notifications about this bug go to: https://bugs.launchpad.net/hwe-next/+bug/1879633/+subscriptions -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
