open-vm-tools-desktop dh_installsystemd -popen-vm-tools-desktop --restart-after-upgrade --no-stop-on-upgrade run-vmblock
=> Maintscripts # Automatically added by dh_installsystemd/13.3.1ubuntu1 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then # This will only remove masks created by d-s-h on package removal. deb-systemd-helper unmask 'run-vmblock\x2dfuse.mount' >/dev/null || true # was-enabled defaults to true, so new installations run enable. if deb-systemd-helper --quiet was-enabled 'run-vmblock\x2dfuse.mount'; then # Enables the unit on first installation, creates new # symlinks on upgrades if the unit file has changed. deb-systemd-helper enable 'run-vmblock\x2dfuse.mount' >/dev/null || true else # Update the statefile to add new symlinks (if any), which need to be # cleaned up on purge. Also remove old symlinks. deb-systemd-helper update-state 'run-vmblock\x2dfuse.mount' >/dev/null || true fi fi # End automatically added section # Automatically added by dh_installsystemd/13.3.1ubuntu1 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if [ -d /run/systemd/system ]; then systemctl --system daemon-reload >/dev/null || true if [ -n "$2" ]; then _dh_action=restart else _dh_action=start fi deb-systemd-invoke $_dh_action 'run-vmblock\x2dfuse.mount' >/dev/null || true fi fi # End automatically added section Qemu as I tried it atm: dh_installsystemd -a -pqemu-system-common --restart-after-upgrade --no- stop-on-upgrade --name=run-qemu.mount Only gets rendered into # Automatically added by dh_installsystemd/13.3.1ubuntu1 if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ] || [ "$1" = "abort-deconfigure" ] || [ "$1" = "abort-remove" ] ; then if deb-systemd-helper debian-installed 'run-qemu.mount'; then # This will only remove masks created by d-s-h on package removal. deb-systemd-helper unmask 'run-qemu.mount' >/dev/null || true if deb-systemd-helper --quiet was-enabled 'run-qemu.mount'; then # Create new symlinks, if any. deb-systemd-helper enable 'run-qemu.mount' >/dev/null || true fi fi # Update the statefile to add new symlinks (if any), which need to be cleaned # up on purge. Also remove old symlinks. deb-systemd-helper update-state 'run-qemu.mount' >/dev/null || true fi # End automatically added section The start section is missing, but why? Both are compat level 12, the commands are the same ... hmmm -- You received this bug notification because you are a member of Ubuntu Bugs, which is subscribed to Ubuntu. https://bugs.launchpad.net/bugs/1913421 Title: Load of pre-upgrade qemu modules needs to avoid noexec To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/qemu/+bug/1913421/+subscriptions -- ubuntu-bugs mailing list ubuntu-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs