Public bug reported:

[Impact]
On Dell systems with Intel Wi-Fi 7 (Sc/Wh, iwlwifi-sc-a0-wh-b0-c102.ucode), 
iwlwifi can hit a firmware error while loading at boot. The driver prints a 
call trace and the Wi-Fi device fails to start. The ODM saw it during warm/cold 
boot stress tests, and it may block shutdown. The hit rateis low.

Error log (kernel 7.0.0-2010-oem, firmware 102.07fca168.0):

  iwlwifi 0000:00:14.3: Detected Intel(R) Wi-Fi 7 BE211 320MHz
  iwlwifi 0000:00:14.3: loaded firmware version 102.07fca168.0 
sc-a0-wh-b0-c102.ucode op_mode iwlmld
  iwlwifi 0000:00:14.3: Microcode SW error detected. Restarting 0x0.
  iwlwifi 0000:00:14.3: Loaded firmware version: 102.07fca168.0 
sc-a0-wh-b0-c102.ucode
  iwlwifi 0000:00:14.3: 0x00000B03 | IML/ROM error/state
  iwlwifi 0000:00:14.3: 0x00000040 | FSEQ_ERROR_CODE
  iwlwifi 0000:00:14.3: FW error in SYNC CMD PHY_CONFIGURATION_CMD
  Call Trace:
    iwl_trans_pcie_send_hcmd_sync+0x38c/0x3a0 [iwlwifi]
    iwl_trans_pcie_send_hcmd+0xbf/0x190 [iwlwifi]
    iwl_trans_send_cmd+0x61/0xf0 [iwlwifi]
    iwl_mld_send_phy_cfg_cmd+0x143/0x1a0 [iwlmld]
    iwl_mld_run_fw_init_sequence+0x116/0x1d0 [iwlmld]
    iwl_mld_load_fw+0x35/0x90 [iwlmld]
    iwl_op_mode_mld_start+0x1ec/0x370 [iwlmld]
    iwl_mld_init+0x1d/0xff0 [iwlmld]

[Fix]
Update iwlwifi-sc-a0-wh-b0-c102.ucode from 102.07fca168.0 to 102.651bbed6.0
(FW_Build_And_Test_For_Users-44855). Intel fixed this in the firmware, and the
fix first landed in core 105. Intel then backported it to the c102 file.

linux-firmware commit:
95751f54eb5c iwlwifi: update Sc/Wh FW for core102

This commit is in linux-firmware main (Nov 4 2026) but not in a dated release
tag yet.

[Test Plan]
Install the updated linux-firmware and reboot. Check the loaded version:
$ sudo dmesg | grep "loaded firmware version"
Expect: 102.651bbed6.0 sc-a0-wh-b0-c102.ucode

Run warm boot and cold boot loops (the ODM used 250 warm and 150 cold cycles):
$ sudo dmesg | grep -E "Microcode SW error|FW error in SYNC CMD"

Without patch: on some boots, "Microcode SW error" and
"FW error in SYNC CMD PHY_CONFIGURATION_CMD" with a call trace. The rate is
low, so many cycles are needed.
With patch: no firmware error and no call trace in any cycle.

ODM result with 102.651bbed6.0 on kernel 7.0.0-1017-oem: 4 Dell systems,
2 rounds each of warm boot (250 cycles) and cold boot (150 cycles). No system
hung and no iwlwifi call trace was seen.

[Where problems could occur]
Could break Wi-Fi on all Intel Sc/Wh devices that load the c102 ucode, such as 
BE211.

If the new firmware has a bug, the device could fail to load it. dmesg would 
show
"Microcode SW error" or "FW error in SYNC CMD". Wi-Fi would not come up, or 
would
drop during use (scan, roam, suspend/resume). Bluetooth runs on the same card, 
so
BT could break too. Earlier test firmware on this ticket seemed to raise the BT
failure rate, so check BT as well.

** Affects: linux-firmware (Ubuntu)
     Importance: Undecided
         Status: New

-- 
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
https://bugs.launchpad.net/bugs/2173720

Title:
  Intel Wi-Fi 7 firmware error and call trace at boot on Dell systems

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/linux-firmware/+bug/2173720/+subscriptions


-- 
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs

Reply via email to