The link does not show a sparc architecture based build. This bug was found on a sparc based version of Gutsy. If you want to point me to this release I would be glad to test it for you.
--Chad On Wed, Feb 13, 2008 at 5:22 PM, Leann Ogasawara <[EMAIL PROTECTED]> wrote: > Hi vipaca, > > It looks like you are running the Gutsy kernel (2.6.22-14). The Hardy > Heron Alpha series was recently released which contains an updated > version of the kernel. Care to test with a Hardy Alpha release? You > can download and try the new Hardy Heron Alpha release from > http://cdimage.ubuntu.com/releases/hardy/ . You should be able to then > test the new kernel via the LiveCD. If you can, please verify if this > bug still exists or not and report back your results. General > information regarding the release can also be found here: > http://www.ubuntu.com/testing/ . Thanks. > > ** Changed in: linux (Ubuntu) > Status: New => Incomplete > > -- > sparc tg3 nic port mismatch > https://bugs.launchpad.net/bugs/191668 > You received this bug notification because you are a direct subscriber > of the bug. > > Status in Source Package "linux" in Ubuntu: Incomplete > > Bug description: > After installing 'uname -a' > Linux ast4-lnx1 2.6.22-14-sparc64 #1 Sun Oct 14 21:57:46 GMT 2007 sparc64 > GNU/Linux > I had no connectivity when I walked around to the back of my Sun Fire v210 > I noticed no lights on the connected port. I moved the cable to deifferent > v210 running solaris and observed lights meaning the connection was good. > When I moved it back to the same port on the original v210 no lights. From > there I moved it down the line find that only the third port of the four > ports had lights. I then decided to configue eth2 to no connectivty was > observed after using ifconfig, so I configured /etc/network/interfaces to > reflect my desired setup and rebooted the box as 'services' package was not > installed. When the box came back up no lights on the third port. Testing > again I saw that I was getting lights on the second port but no others. > > After much searching I came up with this article. > > http://www.mail-archive.com/[EMAIL PROTECTED]/msg20279.html > > After reading I connected Ethernet port 0 and configured eth2. It worked > like a charm. > > snippit from dmesg reporting problems: > > [ 38.472959] tg3: eth%d: Cannot get nvarm lock, tg3_nvram_init failed. > [ 38.810262] eth0: Tigon3 [partno(none) rev 2003 PHY(5704)] > (PCI:66MHz:64-bit) 10/100/1000Base-T Ethernet 00:03:ba:7e:e3:5b > [ 38.810281] eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] > TSOcap[1] > [ 38.810289] eth0: dma_rwctrl[763f0000] dma_mask[32-bit] > [ 38.810328] PCI: Enabling device: (0003:00:02.1), cmd 2 > [ 38.810972] libata version 2.21 loaded. > [ 38.896096] ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller > (OHCI) Driver > [ 39.100973] tg3: eth%d: Cannot get nvarm lock, tg3_nvram_init failed. > [ 39.438160] eth1: Tigon3 [partno(none) rev 2003 PHY(5704)] > (PCI:66MHz:64-bit) 10/100/1000Base-T Ethernet 00:03:ba:7e:e3:5c > [ 39.438178] eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] > TSOcap[1] > [ 39.438186] eth1: dma_rwctrl[763f0000] dma_mask[32-bit] > [ 39.438243] PCI: Enabling device: (0000:00:02.0), cmd 2 > [ 39.438316] PCI: Enabling device: (0002:00:02.0), cmd 147 > [ 39.438902] sym0: <1010-66> rev 0x1 at pci 0002:00:02.0 irq 24 > [ 39.441171] sym0: No NVRAM, ID 7, Fast-80, LVD, parity checking > [ 39.481520] sym0: SCSI BUS has been reset. > [ 39.481532] scsi0 : sym-2.2.3 > [ 39.481695] PCI: Enabling device: (0002:00:02.1), cmd 147 > [ 39.482277] sym1: <1010-66> rev 0x1 at pci 0002:00:02.1 irq 25 > [ 39.484509] sym1: No NVRAM, ID 7, Fast-80, LVD, parity checking > [ 39.524844] sym1: SCSI BUS has been reset. > [ 39.524854] scsi1 : sym-2.2.3 > [ 39.525118] PCI: Enabling device: (0001:00:0a.0), cmd 2 > [ 39.525133] ohci_hcd 0001:00:0a.0: OHCI Host Controller > [ 39.525565] ohci_hcd 0001:00:0a.0: new USB bus registered, assigned bus > number 1 > [ 39.525607] ohci_hcd 0001:00:0a.0: irq 17, io mem 0x7ff01000000 > [ 39.703604] tg3: eth%d: Cannot get nvarm lock, tg3_nvram_init failed. > [ 40.040819] eth2: Tigon3 [partno(none) rev 2003 PHY(5704)] > (PCI:66MHz:64-bit) 10/100/1000Base-T Ethernet 00:03:ba:7e:e3:59 > [ 40.040837] eth2: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] > TSOcap[1] > [ 40.040845] eth2: dma_rwctrl[763f0000] dma_mask[32-bit] > [ 40.040884] PCI: Enabling device: (0000:00:02.1), cmd 2 > [ 40.045182] usb usb1: configuration #1 chosen from 1 choice > [ 40.045246] hub 1-0:1.0: USB hub found > [ 40.045272] hub 1-0:1.0: 2 ports detected > [ 40.247497] tg3: eth%d: Cannot get nvarm lock, tg3_nvram_init failed. > [ 40.584656] eth3: Tigon3 [partno(none) rev 2003 PHY(5704)] > (PCI:66MHz:64-bit) 10/100/1000Base-T Ethernet 00:03:ba:7e:e3:5a > [ 40.584674] eth3: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] WireSpeed[1] > TSOcap[1] > [ 40.584682] eth3: dma_rwctrl[763f0000] dma_mask[32-bit] > > [EMAIL PROTECTED]:/etc/apt$ lspci > 0000:00:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo > Fireplane-PCI bus bridge module [pcisch] > 0000:00:02.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 > Gigabit Ethernet > 0000:00:02.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 > Gigabit Ethernet > 0001:00:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo > Fireplane-PCI bus bridge module [pcisch] > 0001:00:06.0 Non-VGA unclassified device: ALi Corporation M7101 Power > Management Controller [PMU] > 0001:00:07.0 ISA bridge: ALi Corporation M1533/M1535 PCI to ISA Bridge > [Aladdin IV/V/V+] > 0001:00:0a.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03) > 0001:00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c4) > 0002:00:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo > Fireplane-PCI bus bridge module [pcisch] > 0002:00:02.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1010 > 66MHz Ultra3 SCSI Adapter (rev 01) > 0002:00:02.1 SCSI storage controller: LSI Logic / Symbios Logic 53c1010 > 66MHz Ultra3 SCSI Adapter (rev 01) > 0003:00:00.0 Host bridge: Sun Microsystems Computer Corp. Schizo > Fireplane-PCI bus bridge module [pcisch] > 0003:00:02.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 > Gigabit Ethernet > 0003:00:02.1 Ethernet controller: Broadcom Corporation NetXtreme BCM5704 > Gigabit Ethernet > > [EMAIL PROTECTED]:/etc/apt$ lsmod > Module Size Used by > ipv6 310288 12 > ext3 156880 2 > jbd 62288 1 ext3 > mbcache 10248 1 ext3 > sg 37608 0 > sd_mod 28056 3 > ide_cd 36680 0 > cdrom 42664 1 ide_cd > alim15x3 12888 0 [permanent] > ide_core 152552 2 ide_cd,alim15x3 > ohci_hcd 22404 0 > ata_generic 8772 0 > sym53c8xx 85416 2 > scsi_transport_spi 27904 1 sym53c8xx > libata 137344 1 ata_generic > scsi_mod 126960 5 > sg,sd_mod,sym53c8xx,scsi_transport_spi,libata > tg3 125956 0 > dm_mirror 25280 0 > dm_snapshot 20416 0 > dm_mod 66288 7 dm_mirror,dm_snapshot > capability 6088 0 > commoncap 8832 1 capability > fuse 50536 1 > -- sparc tg3 nic port mismatch https://bugs.launchpad.net/bugs/191668 You received this bug notification because you are a member of Ubuntu Bugs, which is the bug contact for Ubuntu. -- ubuntu-bugs mailing list [email protected] https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
