Hi,
In the hope wireless would work again on my IBM Thinkpad X30, I just did a
fresh install of the latest Ubuntu Hardy Alpha. Unfortunately nm-applet does
not show the wireless networks.
Ubuntu boots up with a spinning progress bar (moving left and right
without progress) and hangs during ten seconds. Afterwards Ubuntu boots
up normally. If I blacklist the hostap* drivers the hanging does not
occur.
Wireless worked in Dapper before. How can I get this working again?
Thanks in advance,
Stani
PS Here is some information:
$ uname -a
Linux x30 2.6.24-12-generic #1 SMP Wed Mar 12 23:01:54 UTC 2008 i686 GNU/Linux
$ cat /proc/version_signature
Ubuntu 2.6.24-12.22-generic
$ iwconfig
lo no wireless extensions.
eth1 no wireless extensions.
wifi0 IEEE 802.11b ESSID:" O'Reilly's" Nickname:""
Mode:Managed Frequency:2.452 GHz Access Point: None
Bit Rate:2 Mb/s Sensitivity=1/3
Retry short limit:8 RTS thr:off Fragment thr:off
Power Management:off
wlan0 IEEE 802.11b ESSID:" O'Reilly's" Nickname:""
Mode:Managed Frequency:2.452 GHz Access Point: None
Bit Rate:2 Mb/s Sensitivity=1/3
Retry short limit:8 RTS thr:off Fragment thr:off
Power Management:off
Link Quality=0/70 Signal level=-73 dBm Noise level=-73 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
irda0 no wireless extensions.
$ sudo lshw -C network
[sudo] password for stani:
*-network:0
description: Wireless interface
product: Prism 2.5 Wavelan chipset
vendor: Intersil Corporation
physical id: 2
bus info: [EMAIL PROTECTED]:01:02.0
logical name: wifi0
version: 01
serial: 00:05:3c:06:c2:96
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list logical wireless ethernet physical
configuration: broadcast=yes driver=hostap firmware=1.4.9 latency=64
module=hostap_pci multicast=yes wireless=IEEE 802.11b
*-network:1
description: Ethernet interface
product: 82801CAM (ICH3) PRO/100 VE (LOM) Ethernet Controller
vendor: Intel Corporation
physical id: 8
bus info: [EMAIL PROTECTED]:01:08.0
logical name: eth1
version: 42
serial: 00:09:6b:a0:35:5d
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt
10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=e100
driverversion=3.5.23-k4-NAPI duplex=full firmware=N/A ip=192.168.123.202
latency=66 link=yes maxlatency=56 mingnt=8 module=e100 multicast=yes port=MII
speed=100MB/s
** Attachment added: "lspci -vv"
http://launchpadlibrarian.net/12763215/lspci-vv-stani-x30.txt
--
Orinoco_pci affected by re-enabled prism2 drivers
https://bugs.launchpad.net/bugs/63989
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
