I have the same problem with a sansa clip. In gutsy on my old computer
it mounted ok but only ever at USB 1.1 speeds.
On my new Dell inspiron 530 in fails to mount 95% of the time with:
[ 105.895973] usb 8-3: new high speed USB device using ehci_hcd and address 2
[ 110.517165] ehci_hcd 0000:00:1d.7: port 3 reset error -110
[ 110.517177] hub 8-0:1.0: hub_port_status failed (err = -32)
Sometime after a few minutes (in 5% of cases) it mounts at USB2 (480)
speeds, as shown by right-clicking on desktop icons and selecting
properties and disk.
If I remove the ehci_hcd module with modprobe -r ehci_hcd, and then
reload the module, it immediately mounts the device at USB2 speeds.
However if I unmount, and unplug the device, and then plug it back in,
it fails to mount with the -110, -32 errors as before.
So I'm not sure if its some race condition with the uhci_hcd module, or
a dodgy usb implementation in the device. I have noticed it doesn't take
any notice of eject commands like my old mp3 player.
Its a real shame its such a hassle since its a nice mp3 player than is
one of the few that can play ogg vorbis files also.
** Changed in: ubuntu
Status: New => Confirmed
** Also affects: debian
Importance: Undecided
Status: New
--
usb connect problems
https://bugs.launchpad.net/bugs/231049
You received this bug notification because you are a member of Ubuntu
Bugs, which is subscribed to Ubuntu.
--
ubuntu-bugs mailing list
[email protected]
https://lists.ubuntu.com/mailman/listinfo/ubuntu-bugs
