Hello! I'm using uClinux-dist-20051014 with an lp2292 (arm7tdmi). I tried to compile the gdbserver that is included in uClinux-dist-20051014. But its configure script bails out with "Target not supported by gdbserver." Then I checked config.status, and it says
# This directory was configured as follows ../../configure --host=i686-cp-linux-gnu --target=m68k-elf which don't look right to me for two reasons: - gdbserver's README says it must be configured with host beeing identical to target. This sounds reasonable, since the server runs on the target and it needs to understand the target architecture. - m68k-elf is oviously not correct for arm7tdmi. I found a description on ucdot: http://www.ucdot.org/article.pl?sid=03/01/07/0214244&mode=thread but this description seems to assume that the sources are already configured for arm architecture. Any hints how to configure gdb for arm7tdmi? Do I need to start from vanilla sources? _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev
