Hi
I'm using Linux Kernel 2.6.10 for Coldfire 5485 in an embedded application.
I developped my own device-driver (Profibus), working on the internal
UART of the coldfire.
This Driver produces heavy hard-interrupt und soft-irq load, because
UART Data is received and transmitted with 93750 bit/s.
But the driver works fine and communicates with other devices as it
should do. No Kernel-oops.
Now i have the situation, that when i try to start some user program
like "ls" or "ps" ... out of an interactive bash,
sometimes i get a message "Segmentation fault" and the program isn't
started. Then i try again and this time it works.
This shows up in any standard user programm (most of them inside
busybox), but it happens only about every 100th try.
free shows over 1 Megabyte of free memory. I cannot believe, that the
problem is in all of the user programms.
I deactivated my driver and (bad world) no problem anymore.
So my question is:
How can an error inside a device driver produce problems in starting
user programs?
Of course i looked at the kmalloc()'s in my driver, but there are only
very few. They are only called on driver driver initialisation.
I could see no obvious problems yet with the allocated memory.
Hope, somebody can help me
--
------------------------------------------------------------------------
Jürgen Pfeiffer
* _mailto:[EMAIL PROTECTED]
SesKion Softwareentwicklung und System Konzeption GmbH
( : +49-711-9905814
Karlsruher Str. 11/1
Fax: +49-711-9905827
70771 Leinfelden-Echterdingen
1 _http://www.seskion.de_
Vertretungsberechtigte Geschäftsführer:
Gerhard Kuhn,
Jürgen Pfeiffer,
Horst Tabel.
Handelsregister:
HRB 224379
Amtsgericht Stuttgart
Unsere Ust-IdNr.:
DE189769369
Unsere Steuernummer:
99060 / 04155
------------------------------------------------------------------------
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
