Hi Faeze,
faeze asdaghi wrote:
I'm using ADI Coyote board with IXP425network processor and snapgear 3.4
with 2.4 kernel.
I ca't reboot my board.I use reboot of busybox.
when it try to reboot. LEDs turn on and off and "+" shown on screen, but
nothing else happen.
Sounds like a redboot problem then. Redboot prints the "+".
n kernel output there is below line:
RedBoot says flash is at 50000000, but it's actually at 0
The flash is at 0x50000000. On reboot it is also mapped at 0 for
initial boot strapping. But most boot loaders then enable RAM
to be mapped from 0 once it is initialized. (Even if not the
flash is still addressable at 0x50000000).
why this mean?
maybe it be the reason of problem in rebooting the board?
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Chief Software Dude EMAIL: [EMAIL PROTECTED]
Secure Computing Corporation PHONE: +61 7 3435 2888
825 Stanley St, FAX: +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia WEB: http://www.SnapGear.com
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
