Fixes for USB drivers (sl811/isp116x)
Signed-off-by: Atle Nissestad <[EMAIL PROTECTED]>
diff --git a/linux-2.6.x/arch/nios2nommu/kernel/usb.c
b/linux-2.6.x/arch/nios2nommu/kernel/usb.c
index 777eb50..65655b6 100644
--- a/linux-2.6.x/arch/nios2nommu/kernel/usb.c
+++ b/linux-2.6.x/arch/nios2nommu/kernel/usb.c
@@ -34,7 +34,7 @@
#if defined(CONFIG_USB_SL811_HCD) || defined (CONFIG_USB_SL811_HCD_MODULE)
#if defined(CONFIG_MICROTRONIX_STRATIX) || defined (CONFIG_MICROTRONIX_CYCLONE)
-#include <linux/usb_sl811.h>
+#include <linux/usb/sl811.h>
#define SL811_ADDR ((unsigned int)na_usb)
#define SL811_IRQ na_usb_irq
@@ -108,7 +108,7 @@ subsys_initcall(mtx_kit_usb_init);
#if defined(CONFIG_USB_ISP116X_HCD) || defined (CONFIG_USB_ISP116X_HCD_MODULE)
-#include <linux/usb_isp116x.h>
+#include <linux/usb/isp116x.h>
#define ISP116X_HCD_ADDR ((unsigned int)na_usb)
#define ISP116X_HCD_IRQ na_usb_irq
@@ -137,28 +137,15 @@ static struct resource isp116x_hcd_resources[] = {
static struct isp116x_platform_data isp116x_data = {
// Enable internal resistors on downstream ports
- .sel15Kres = 0,
- // Clock cannot be stopped
- .clknotstop = 1,
+ .sel15Kres = 1,
// On-chip overcurrent protection
- .oc_enable = 0,
+ .oc_enable = 1,
// INT output polarity
.int_act_high = 0,
// INT edge or level triggered
.int_edge_triggered = 0,
- // End-of-transfer input polarity
- .eot_act_high = 0,
- // DREQ output polarity
- .dreq_act_high = 1,
- // WAKEUP pin connected
- .remote_wakeup_connected= 0,
// Wakeup by devices on usb bus enabled
.remote_wakeup_enable = 0,
- // Switch or not to switch (keep always powered)
- .no_power_switching = 1,
- // Ganged port power switching (0) or individual port power switching
(1)
- .power_switching_mode = 0,
- .reset = NULL /* isp116x_reset */,
.delay = isp116x_delay,
};
--
1.5.3.2
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
