Hi Kunal,
i would suggest to use Z-Modem (lrzsz) to download the application
from the host. Just compile it into the image ( I think this is
somewhere in misc Applications in the uClinux config). Then type rz
on the command-Prompt and then send the file via the z-modem Protocol
from your terminal emulator (minicom/Hyperterminal/etc).
Greetings,
Peter
On Mar 24, 2008, at 5:35 PM, Kunal Singh wrote:
Hi,
I am running uCLinux on Coldfire-5250 board.
The network port on the board is dead, so I can not use any file
transfer (from Host to Target) through ethernet.
This has become a bottleneck for the development.
Every time I want to get any file on the target (from Host), I
have to re-flash the board (with ROM-fs image).
This takes 5-6 minutes.
REQUIREMENT:
Is there any utility/code which I can use to transfer files via
RS-232 serial port ttyS0?
I am running minicom on the Host, using which I can transfer the
files.
Is there any complimentary which I can use on target?
Regards,
Kunal
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
