Hi all, I'm using a customized Freescale M5329EVB-based board, and want to use the third Coldfire serial port. The first two serial ports of the mcf5329 chip work fine, as one would expect; however, the third doesn't. Looking at the kernel boot messages, I see the following:
ColdFire internal UART serial driver version 1.00 ttyS0 at 0xfc060000 (irq = 90) is a builtin ColdFire UART ttyS1 at 0xfc064000 (irq = 91) is a builtin ColdFire UART Does anyone know why the third port is not showing up, and what I should do to fix that? I'm guessing a (hardware) pin conflict between the third serial port and other on-chip peripherals may be the reason the third port isn't supported, but perhaps I'm confused. TIA, -Bob _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev
