Hi David,
David Wu wrote:
This patch applys to user/can4linux in uClinux-dist-200808008.
can_send.c
-- added set_mask() to setup MASK for RX frame ID
-- modified test3 to test more byte patterns and make sure each
pattern is unique
receive.c
-- added option to change baud rate
-- added option to set mask
-- option "t" for continuous test
transmitter will send 6 group of data continuously
receiver will check each 6 group of data with the first 6 group of
data.
receiver will exit on mismatch.
example:
run "receive -t -b 500" on receiver
and then run "can_send -m -b 500 -D can0 -t3 -s10" on trasmitter
I am not at all familiar with this code :-)
I would like to hear comments from anyone else that uses it,
or is familiar with it.
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Chief Software Dude EMAIL: [EMAIL PROTECTED]
Secure Computing Corporation PHONE: +61 7 3435 2888
825 Stanley St, FAX: +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia WEB: http://www.SnapGear.com
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
