Hi all,
I'm using a LPC2468 ARM processor and I've updated u-boot to version
2008.10. When I run the standard kernel which is supplied by
EmbeddedArtists the board resets itself immediatly after printing
"starting the kernel...". I've no clue on where to start to tackle that
problem. Is there any documentation on the lowlevel stuff in uClinux?
Thanks in advance,
Remco Poelstra
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
