Hello,
I'm having trouble with getty and stty. Basically, I need to have the
uClinux board boot up at a specific baud rate for the Console (ttyS0).
On the Atmel NGW100, the following code in our /etc/inittab file worked
(changed to 9600 baud after booting):
ttyS0::respawn:/sbin/getty -L 9600 ttyS0
But now on a different board, I'm getting an 'L: applet not found' error.
An when I remove 'L', I get the error '9600: applet not found'. Also having
the same problem with stty.
Does anyone recognize the problem?
Thank you,
Tom
--
Tom Stalcup
Upward Innovations Inc.
www.UpwardInnovations.com
Phone: (877) 943-4328 ext. 701
Fax: (508) 495-0956
_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
