Jivin Mike Frysinger lays it down ... > On Sun, Jul 12, 2009 at 20:01, David McCullough wrote: > > Jivin David McCullough lays it down ... > >> > at any rate, in the process of fixing my inverted logic, it looks like > >> > some were left behind. you'll want to drop the AC_SUBST() right after > >> > the AC_ARG_ENABLE(): > >> > +AC_SUBST(use_ld_elf2flt_script) > >> > > >> > and then at the end, you used the _script instead of the _binary: > >> > +if test "$use_ld_elf2flt_script" = "yes" ; then > >> > +AC_OUTPUT(ld-elf2flt) > >> > +fi > >> > >> Yep, thanks, I didn't quite get back to figuring out why it only built > >> ld-elf2flt (the script) at build time and not at configure time ;-) > >> > >> So I think what I have ready to commit is good to go. Haven't seen any > >> comments strongly against it, so later today or tomorrow I'll check it in, > > > > All done, checkout it out and see if I managed to break it ;-) > > one more ... the "all" target should not be depending on "ld-elf2flt" > anymore as this is handled through the PROG vars. it isnt a problem > for Linux systems, but when EXEEXT is set, things go boom.
Done Thanks, Davidm -- David McCullough, david_mccullo...@securecomputing.com, Ph:+61 734352815 McAfee - SnapGear http://www.snapgear.com http://www.uCdot.org _______________________________________________ uClinux-dev mailing list uClinux-dev@uclinux.org http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by uclinux-dev@uclinux.org To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev