Hi all, we are using a custom board based on the SenTec Cobra 5329 Board. So far it is running with kernel 2.6.17 and we want to switch to uClinux-dist-20080808 release. It compiles fine, but when i want to boot the Kernel by going to the base address after downloading the image with dbug, i get no output. Not one single character. Since i use the same boot parameters as bevore (console=ttyS0,115200) i had a look at the serial drivers an noticed that there have been some changes. So far i was not able to find out what i have to change to get the console output running. Does anybody have a hint what i have to change, to get the console working? Or has anybody had the same behaviour and it was caused by something else? Thanks for any help
Regards Christian _______________________________________________ uClinux-dev mailing list [email protected] http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by [email protected] To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev
