Hi David,
David Wu wrote:
bug fix for RTC RX-8025.
- should use read_block_data() instead of i2c_smbus_read_i2c_block_data()
- require to shift left 4 bits in ds1307_read_block_data_once() and
ds1307_write_block_data()
- if using ds1307_read_block_data_once(), then standard read mode is
used and it is 0x0, there is no read mode of 0x08.
- does not require 0x08 (tranfer mode setting, 0x08 is not valid) in
i2c_smbus_write_byte_data()
this patch applies to uClinux-dist-20090618-20091129.patch set.
I would suggest sending this one to linux-ker...@vger.kernel.org.
That code in the uClinux-dist/linux-2.6.x source is unchanged from
mainline. And according to Linus' git logs it gets regular attention.
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Principal Engineer EMAIL: g...@snapgear.com
SnapGear Group, McAfee PHONE: +61 7 3435 2888
8 Gardner Close FAX: +61 7 3217 5323
Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
