Hello,
I am new to this group and hope to get some informations about uclinux
on bf537.
I have srv-1 board with bf537 blackfin.
On the webpage of srv-1 a linux image and a u-boot can be downloaded.
if I flash them to my srv-1 it works ok. So I decided to compile my own
uclinux. I used the source tarball from blackfin.uclinux.org.
Compiling runs well and a uImage.ext2 is generated.
If I flash it to my blackfin:
I get the following output on serial console, crashing with "Bad Data
CRC". What's wrong? what do I have to change to run my own compiled linux.
I also tried to compile my own u-boot. I compiles well, too.
But flashed to the bf537 on srv-1 it doesn't boot.
Any hints?
Thanks
-------------------------------------------------------
U-Boot 1.1.6-svn985 (ADI-2007R2-pre) (Nov 1 2007 - 18:50:42)
CPU: ADSP bf537-0.2 (Detected Rev: 0.3)
Board: Surveyor SRV1 board
Support: http://www.surveyor.com/
Clock: VCO: 442 MHz, Core: 442 MHz, System: 88 MHz
SDRAM: 32 MB
.In: serial
Out: serial
Err: serial
Net: Blackfin EMAC
I2C: ready
Hit any key to stop autoboot: 0
EEPROM @0x0 read: addr 01000000 off 30000 count 3276800 ...
..................................................done
## Booting image at 01000000 ...
Image Name: uClinux Kernel and ext2
Created: 2010-04-08 19:49:18 UTC
Image Type: Blackfin Linux Kernel Image (gzip compressed)
Data Size: 3590266 Bytes = 3.4 MB
Load Address: 00400000
Entry Point: 005ad104
Verifying Checksum ... Bad Data CRC
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
