Hi Philippe,
Philippe De Muyter wrote:
Fix tcdrain on coldfire uarts. Currently with coldfire uarts tcdrain returns without waiting for txempty, because (tx)fifosize is 0. Fix that and call uart_update_timeout when setting the baud rate, otherwise tcdrain will wait for an half our :) Also constify mcf_uart_ops. Signed-off-by: Philippe De Muyter <p...@macqel.be>
Looks good, thanks. Applied to the m68knommu git tree. Regards Greg
diff --git a/arch/m68k/include/asm/mcfuart.h b/arch/m68k/include/asm/mcfuart.h index ef22938..01a8716 100644 --- a/arch/m68k/include/asm/mcfuart.h +++ b/arch/m68k/include/asm/mcfuart.h @@ -212,5 +212,10 @@ struct mcf_platform_uart { #define MCFUART_URF_RXS 0xc0 /* Receiver status */ #endif+#if defined(CONFIG_M5272)+#define MCFUART_TXFIFOSIZE 25 +#else +#define MCFUART_TXFIFOSIZE 1 +#endif /****************************************************************************/ #endif /* mcfuart_h */ diff --git a/drivers/serial/mcf.c b/drivers/serial/mcf.c index 7bb5fee..b9f7dfe 100644 --- a/drivers/serial/mcf.c +++ b/drivers/serial/mcf.c @@ -263,6 +263,7 @@ static void mcf_set_termios(struct uart_port *port, struct ktermios *termios, }spin_lock_irqsave(&port->lock, flags);+ uart_update_timeout(port, termios->c_cflag, baud); writeb(MCFUART_UCR_CMDRESETRX, port->membase + MCFUART_UCR); writeb(MCFUART_UCR_CMDRESETTX, port->membase + MCFUART_UCR); writeb(MCFUART_UCR_CMDRESETMRPTR, port->membase + MCFUART_UCR); @@ -379,6 +380,7 @@ static irqreturn_t mcf_interrupt(int irq, void *data) static void mcf_config_port(struct uart_port *port, int flags) { port->type = PORT_MCF; + port->fifosize = MCFUART_TXFIFOSIZE;/* Clear mask, so no surprise interrupts. */writeb(0, port->membase + MCFUART_UIMR); @@ -424,7 +426,7 @@ static int mcf_verify_port(struct uart_port *port, struct serial_struct *ser) /* * Define the basic serial functions we support. */ -static struct uart_ops mcf_uart_ops = { +static const struct uart_ops mcf_uart_ops = { .tx_empty = mcf_tx_empty, .get_mctrl = mcf_get_mctrl, .set_mctrl = mcf_set_mctrl,
-- ------------------------------------------------------------------------ Greg Ungerer -- Principal Engineer EMAIL: g...@snapgear.com SnapGear Group, McAfee PHONE: +61 7 3435 2888 8 Gardner Close FAX: +61 7 3217 5323 Milton, QLD, 4064, Australia WEB: http://www.SnapGear.com _______________________________________________ uClinux-dev mailing list uClinux-dev@uclinux.org http://mailman.uclinux.org/mailman/listinfo/uclinux-dev This message was resent by uclinux-dev@uclinux.org To unsubscribe see: http://mailman.uclinux.org/mailman/options/uclinux-dev
