Hello
I'm trying to get uClinux 2010 to detect and work with a Samsung
256MiB 3,3V 8bit NAND (ID=0xec (236) and Chip ID=0xda (218)), but
after booting up, dmesg says:
======
...
Found mtd parition at 0x0020a000, (len=0x800000), moving to 0x03700000
...
uclinux[mtd]: RAM probe address=0x3700000 size=0x800000
Creating 1 MTD partitions on "RAM":
0x000000000000-0x000000800000 : "ROMfs"
mtd: Giving out device 0 to ROMfs
Generic platform RAM MTD, (c) 2004 Simtec Electronics
No NAND device found.
======
There are several parameters that can be changed in the board
resources file, but I have no idea what to try (CLE/ALE, GPIO ready
pin + PORT/BIT_MASK, chip_delay, start/end adresses, etc.)
Has someone successfully gotten uClinux to work with that NAND and
knows what parameters I should try?
If there is a better venue where to ask, please point me in the right
direction.
Thank you for any help.
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
