Hi Daniele,
On Thu, Apr 10, 2014 at 5:47 PM, Daniele Ziglioli
<dani...@signal-elettronica.it> wrote:
> I've then started from the config of the M5272C3 EVB (that is is the more
> similar to mine),
> and changed kernel execution form add 0x400.
> The same I've done before with a linux-2.4 kernel, and that work.
> But when i do go 0x400 nothing happen on the console.
> I've an ICDFZ 64K (P&E) and the only thing that I could see , looking the
> address of the assembler line
> where the cpu is looped in the "calibrate_delay" function.
If it's looping while calibrating the delay loop, the timer interrupt
is probably
not working.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- ge...@linux-m68k.org
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev
