At present, an instance of ConceptMapper can only load one dictionary.
You would have to either merge dictionaries into one, or run multiple
passes of ConceptMapper, using different configurations. The ability
to load multiple dictionaries would be a nice enhancement...
On Jun 19, 2008, at 3:12 PM, Ahmed Abdeen Hamed wrote:
My apologies that my question wasn't clear enough. I am trying to
use the
ConceptMapper example that was posted on the list a couple of days
ago.
However, the example came with one dictionary only. I have a need to
access
more than one dictionary. So, I created a primitive AE similar to the
ConceptMapperOffsetTokenizer.xml and I added its entry to the
aggregate AE
OffsetTokenizerMatcher.xml. However, the only dictionary that get
loaded
when the two primitive ones are listed on the aggregate is the
dictionary
listed in the ConceptMapperOffsetTokenizer.xml, not the second
dictionary
that I just created. On the other hand, if I list only one of them
in the
aggregate AE, the correct dictionary gets loaded.
To make my long story short, how does a dictionary file get loaded?
What
sort of parameters that needs to be set and where? Is it possible to
load
more than one dictionary?
Thanks,
Ahmed
On Thu, Jun 19, 2008 at 2:43 PM, LeHouillier, Frank D. <
[EMAIL PROTECTED]> wrote:
I should also say that this sort of question is better for the
uima-user list than the developers list. The developers list is for
people actually working on the framework.
-----Original Message-----
From: LeHouillier, Frank D.
Sent: Thursday, June 19, 2008 2:20 PM
To: '[EMAIL PROTECTED]'
Subject: RE: ConceptMapper with multiple dictionaries
Your question isn't entirely clear, but if you mean that you expect
the
aggregate analysis engine to produce a CAS with more general
annotations
than was produced by the primitive AE's (perhaps because of the
Capabilities), this thread might be helpful:
http://mail-archives.apache.org/mod_mbox/incubator-uima-user/200805.mbox
/[EMAIL PROTECTED]
Hope that helps.
-----Original Message-----
From: Ahmed Abdeen Hamed [mailto:[EMAIL PROTECTED]
Sent: Thursday, June 19, 2008 2:09 PM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: ConceptMapper with multiple dictionaries
Hello UIMA developers,I am trying to build an aggregate AE engine
that
uses ConceptMapper and access more than one dictionary. I am not
getting
any errors, but I am always getting a specific primitive AE results
when
I list them in the aggregate one. Is there a straightforward way to
do
that?
Thanks for your time!
Ahmed
