Marshall, I realized there wasn't any need for specifying additional user parameters, as you indicated, there isn't any coding required for modifying CPE at the manager level. Please consider the matter as closed.
Thanks! Nick -----Original Message----- From: Marshall Schor [mailto:[email protected]] Sent: Thursday, April 02, 2009 4:00 PM To: [email protected] Subject: Re: User configuration params in CPE descriptor Duan, Nick wrote: > Is there any way to specify a user-defined parameter in CPE descriptor > (like what you can do in CPE components' descriptors)? > I don't think I quite understand what you're asking for. The CPE descriptor has a place for specifying user-defined parameters, within each component (which you may be acknowledging with your parenthesized remark). If you''re asking about other user-defined parameters - what would be "user" of these? (There's no user-written code other than what is in the components.) Please say more details if this doesn't address your question. -Marshall > Thanks! > > Nick > This communication, along with any attachments, is covered by federal and state law governing electronic communications and may contain company proprietary and legally privileged information. > If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution, use or copying of this message is strictly prohibited. > If you have received this in error, please reply immediately to the sender and delete this message. Thank you. > > > > This communication, along with any attachments, is covered by federal and state law governing electronic communications and may contain company proprietary and legally privileged information. If the reader of this message is not the intended recipient, you are hereby notified that any dissemination, distribution, use or copying of this message is strictly prohibited. If you have received this in error, please reply immediately to the sender and delete this message. Thank you.
