The screen flies by too fast to read when it loads the e100.dos hardware driver but it ends as follows: (which I assume means it was successful?)
Defaulting to NIC found in slot 0x0028. PCI\VEN_8086&DEV_103D&SUBSYS_00011179&REV83 Permanent Node Address 00080DB367F4 Current Node Address 00080DB367F4 Configuration Speed AUTO Transmit Buffers 4 Receive BUffers 8
## I would have assumed at this point that the e100b.dos loaded successfully?
It then goes on to say:
DOS TCP/IP
The command completed successfully.
LAN Manager Netbind
Error 36 Unable to bind. Hardware failure.
NET0125: NETBIND must be executed before TCP/IP TSR module is loaded. Unloadable TCP 1.0 not loaded.
## This I find confusing? I thought it said a few lines earlier that DOS TCP/IP loaded successfully?
NET0116: TCP Access failure by Tiny RFC. press any key to continue Error 7361, IPX or NetBIOS must be running in order to load the network.
-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3
_______________________________________________
unattended-info mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/unattended-info
