After some research this is how I am going to set up my bonding. What do you guys think? Daisy chain #8green marine grade wire from starboard engine -shaft log -strut - fuel deck fill - fuel filter housing - sea cock - rudder- trim tab-one side of large zinc plate on transom. Same thing down the port side but and sea cocks in the center of the boat. I will also be running a wire from the grounding bus of the AC panel to the bonding system and wire from the grounding bus on my new dc panel either to the bonding system or to the grounding bus on the AC panel(shouldn’t matter if because AC panel is already connected to bonding system) I will also run grounds from VHF and other electronics to the ground bus on the dc panel. I have recherché that the proper way to bond involves using on long no insulated strip down the center of the boat and branching out from there but I would prefer to do it as I described above, how are your boats set up? Does anyone run some sort of brush system to better bond your props and shafts?
Thanks, Matt --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "UnifliteWorld" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/unifliteworld?hl=en -~----------~----~----~----~------~----~------~--~---
