JackOfAll wrote: > Download the carrier board circuit diagram frrom the Wandboard site and > you'll be able to figure out where to tap I2S going to the sgtl5000.
Hmm, i downloaded it and i found the page where i can see i2s going into sgtl500, but i am thinking about getting i2s from the expansion pin headers without soldering and connect it to Buffalo II. I found that CTRL_CLK, wihich is probably Bit Clock on R pi is available on expansion pin board 3.9, 3.13, 3.17 - I2C1_SCL, I2C2_SCL, I2C3_SCL Than I2S_LRCLK which is probably LRCK is connected to AUD3_TXFS and AUD5_TXFS, but not to expansion pins. Then same is for I2S_DOUT0, it is probably Data Out and is connected to AUD3_TXD and AUD5_TXD, but not to expansion pins. Any hints ? ------------------------------------------------------------------------ praganj's Profile: http://forums.slimdevices.com/member.php?userid=41091 View this thread: http://forums.slimdevices.com/showthread.php?t=99395 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
