Krisbee wrote: 
> -
> The best laid schemes o' mice an' men- ...  Thanks for given it go, at
> least some progress was made.  Looking elsewhere for hints re:
> cubietruck network  problems didn't show anything obvious.  But I
> belatedly realised that the current version of Triode's cubietruck
> installer tries to download firmware for the inbuilt bluetooth/wifi
> combo chip ( ap620 ?) from what is now a non-existant source.  However
> the ethernet module ought to be loaded and must at least have worked
> initally. If stuff is dropping off your network, is it possible you have
> a switch/router problem (dhcp leases or something ?).
> 
> Without a cubietruck to work on, I'm in the dark. Here are couple of
> threads over at "Arch Linux Arm" which show just how things can change:
> 
> http://archlinuxarm.org/forum/viewtopic.php?f=33&t=8218&start=10
> http://archlinuxarm.org/forum/viewtopic.php?f=33&t=8665
> 
> I didn't realsie until today that "Arch Arm Linux" had listed the
> Cubietruck as one of thier supported ArmV7 platforms :
> http://archlinuxarm.org/platforms/armv7/allwinner/cubietruck
> 
> If you fell like a repeat, you could follow the instructions on that
> page to create a basic Arch SD card image, which should a least allow
> you to test your cubietruck ethernet.  Not too many steps, and you can
> just cut & paste them into a linux command line.  I supose it's possilbe
> to take some of Triode's installer script to get his work installed on
> top of that.

Thanks Chris, I'll try later in the week.

I think the network problem is specific to the SoA image as when i tried
volumio that was rock solid.

Also the Cubietruck/SoA was used at two different locations.

atb

Ronnie


------------------------------------------------------------------------
Man in a van's Profile: http://forums.slimdevices.com/member.php?userid=43627
View this thread: http://forums.slimdevices.com/showthread.php?t=101624

_______________________________________________
unix mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/unix

Reply via email to