Hijacking this thread as it looks like a good place to continue the discussion without creating another thread.
I've got pcp4 on a Pi3 B+ with the 7" screen, the 38 kHz TSOP4838 and the standard LIRC setup using a standard Squeezebox remote (currently using standard audio out, no DAC, no LMS, no "special" settings). Using IRW I can see that each button press is a single event, but sometimes, Jivelite seems to act like loads of button presses took place. I can turn Jivelite off reliably using the power button (power toggle), but a single press (shown in IRW) turns it on and straight back off again (you get work round this by using pretty much any other button to turn it back on again). I also find on the odd occasion that a single volume up or down will cause Jivelite to increase volume to max (if up was pressed) or to Mute (if down was pressed) - not immediately but it acts like the volume up or down button has been held down until the volume won't go any further in that direction. The rest of the time, the response to the remote feels a little sluggish, and is far less snappy than a real Squeezebox (which is a shame, but the read Squeexebox is VERY snappy to remote presses!). I have the standard min_repeat 1 suppress_repeat 6 in the standard lirc.conf. Anybody seen the same thing - any ideas? (pretty please :) ) Cheers, Matt. ------------------------------------------------------------------------ mutant_matt's Profile: http://forums.slimdevices.com/member.php?userid=37288 View this thread: http://forums.slimdevices.com/showthread.php?t=106292 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
