ralphy wrote:
> The pcp 4.19.40 kernel includes the rc media driver for your dongle.
>
> >
Code:
--------------------
> > modinfo mceusb.ko | grep 815
> alias: usb:v0471p0815d*dc*dsc*dp*ic*isc*ip*in*
--------------------
> >
>
> Try removing lirc and reboot.
> Confirm jivelite is installed then install IR-tools for jivelite and
> reboot.
>
> Run sudo ir-keytable to see if the device is found.
> If yes, then try the steps outlined in post #1.
Hi ralphy
Ok, yes, the kernel support seems to be there. sudo ir-keytable gives
Code:
--------------------
Found /sys/class/rc/rc1/ (/dev/input/event1) with:
Name: Media Center Ed. eHome Infrared Remote Transceiver (0471:0815)
Driver: mceusb, table: rc-rc6-mce
LIRC device: /dev/lirc1
Supported kernel protocols: lirc rc-5 rc-5-sz jvc sony nec sanyo mce_kbd rc-6
sharp xmp imon
Enabled kernel protocols: lirc rc-6
bus: 3, vendor/product: 0471:0815, version: 0x0000
Repeat delay = 500 ms, repeat period = 125 ms
--------------------
.... which is a good start. However, sudo ir-keytable doesn't give any
response - I assume because it's listening on GPIO 25. How do we tell
it to listen on /dev/lirc1 instead?
------------------------------------------------------------------------
psketch's Profile: http://forums.slimdevices.com/member.php?userid=56555
View this thread: http://forums.slimdevices.com/showthread.php?t=110640
_______________________________________________
unix mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/unix
