Getting there. I've discovered the modprobe commands to install the
framebuffer:
Code:
--------------------
modprobe flexfb setaddrwin=0 width=240 height=240
init=-1,0x11,-2,120,-1,0x36,0x00,-1,0x3A,0x05,-1,0xB2,0x0C,0x0C,0x00,0x33,0x33,-1,0xB7,0x35,-1,0xBB,0x1A,-1,0xC0,0x2C,-1,0xC2,0x01,-1,0xC3,0x0B,-1,0xC4,0x20,-1,0xC6,0x0F,-1,0xD0,0xA4,0xA1,-1,0x21,-1,0xE0,0x00,0x19,0x1E,0x0A,0x09,0x15,0x3D,0x44,0x51,0x12,0x03,0x00,0x3F,0x3F,-1,0xE1,0x00,0x18,0x1E,0x0A,0x09,0x25,0x3F,0x43,0x52,0x33,0x03,0x00,0x3F,0x3F,-1,0x29,-3
modprobe fbtft_device name=flexfb speed=32000000 cs=1 gpios=dc:9
--------------------
With these added to /opt/bootlocal.sh and the following
Code:
--------------------
fbcon=map:10 fbcon=font:PEARL8x8
--------------------
added the end of to cmdline.txt the system will boot up with console
messages on the display.
I've also created a /mnt/mmblk0p2/tce/jivelite.sh file to start Jivelite
on /dev/fb1, but it currently exits immediately after starting.
------------------------------------------------------------------------
JQW's Profile: http://forums.slimdevices.com/member.php?userid=66930
View this thread: http://forums.slimdevices.com/showthread.php?t=110727
_______________________________________________
unix mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/unix
