HI,
I got a new Pirate audio 3w amp board end of last week. Installed Jivelite etc as post #348. but Y switch did not work. After a day poking about, I came across the warning in the thread that Pimoroni had changed from GPIO 20 to 24. You sbpt script still calls up the old GPIO:- # button Y SW4=20 SH4=KEY:KEY_DOWN #LO4=KEY:KEY_LEFT LO4=KEY:KEY_ESC LMS4=250 I changed the 20 to 24 and everything works fine on my setup now! Please, Please could you put a warning in your instructions to make people aware of the choice and that an edit may have to be made. It would save a lot of grief! I had a winge to Pimoroni that they should have put an obvious warning, not just buried it as an issue on github, and purhaps made the boards rev controlled! Many thanks for a superb job regards Patrick ------------------------------------------------------------------------ superpat999's Profile: http://forums.slimdevices.com/member.php?userid=9340 View this thread: http://forums.slimdevices.com/showthread.php?t=111502 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
