Hi
I have just installed your 2020 LMS monitor, following your guide in Git hub. >From boot up, my 2.4" I2C Oled display, (pi 3b, picoreplayer v6.1,) trying these commands in Tweeks in picoreplayer :- /mnt/mmcblk0p2/tce/gomonitor rn or /mnt/mmcblk0p2/tce/gomonitor vu,sa,pk,st -o6 -x 0x3c -db The display shows 1. The splash screen, 2. the IP address, if slimserver not playing then 3) I see the large digital clock and date. If slimserver is playing then 3), I see the song information page with song and artist information stepping left and right, the timer decrementing etc, after the start up logo. and IP pages. There is a letter "H" shownp permanently on the top right hand corner that I do not understand the significance. Whilst showing playing information, after some seconds the screen goes blank and stays blank until I restart the lms monitor. Although though I asked for Visualization (VU) in the command line, I never see the vu (or any other visualization ) displayed However I can ask for any of the Egg displays in the command line and these are displayed OK. Since I have only just installed your monitor, I am in a learning curve, I have read all the previous replies to this thread but I cannot see why I cannot see Vu meters displayed. I would be very grateful if you could suggest the best fault finding method to solve this problem Although I set -V in the command line, I have not found any error output, Where is this recorded? many thanks Patrick ------------------------------------------------------------------------ superpat999's Profile: http://forums.slimdevices.com/member.php?userid=9340 View this thread: http://forums.slimdevices.com/showthread.php?t=111790 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
