Hello,
I’m completely new here and have little technical knowledge. I recently bought a Raspberry Pi with an Allo Boss 1.2 DAC. I managed to get it running with PiCorePlayer and LMS. I was so proud! Currently I use the webinterface of PiCorePlayer to shut it down and then power it off by pulling the power plug. Of course that works fine but I’d rather have a switch to power on and off the Raspberry/Allo Boss combo. I already did some research on the web and found out that the GPIO-connectors could be of some help. I already bought a normally open button but I don’t know how to connect it to the Allo Boss which is on top of the Raspberry (I already soldered two female GPIO-wires to it). Technical specs of the Allo Boss are available (since this is my first post I’m not allowed to insert a hyperlink to the document) but I don’t know which GPIO-connector of the J19 pins out on the Boss can be used for the normally open button. Can somebody help me out with this? E.g. is it a good idea to use a normally open button? Is there some kind of guide to help me out? Thanks in advance for your kind help. ------------------------------------------------------------------------ Cured's Profile: http://forums.slimdevices.com/member.php?userid=70857 View this thread: http://forums.slimdevices.com/showthread.php?t=109270 _______________________________________________ unix mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/unix
